Maytag MMV4203DB Installation Instructions - Page 4
Instructions - install
UPC - 883049158532
View all Maytag MMV4203DB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INSTALLATION R@mOV@ M _¸_°_ti_ _¸ 12l"_1_' (._ NOTE: To avoid possible damage to the work surface, cover the work surface. 1. Remove any remaining contents from the microwave oven cavity. 2. Remove the 2 screws that attach the mounting plate to the back of the microwave oven, then remove mounting plate and set aside. , \ INSTRUCTIONS 2. Remove the blower motor screw from the back of the microwave oven, then lift out blower motor. 6 A. Blower motor B. Blower motor screw 3. Using diagonal wire cutting pliers, snip out the rear damper vent covers at the perforations. - S r-'' ooooooooooo¢o==zo== ooooIoooooooo [30 000_ 00000_ 0000000000000000 0[3 A B A. Mounting plate B. Back of microwave oven 3. Reattach the 2 screws. 4. Tape the microwave oven door closed so that door does not swing open while the microwave oven is being handled. NOTE: To avoid damage to the microwave oven, do not grip or use the door or door handle while the microwave oven is being handled. IZO al : ' The microwave oven is set for recirculation installation. For wall or roof venting, changes must be made to the venting system. NOTE: Skip this section if you are using recirculation installation. Keep the damper assembly in case the venting method is changed, or the microwave oven is reinstalled in another location where wall or roof venting may be used. Wall Venting Installation Only 1. Remove damper plate screw and top blower motor screw attaching damper plate to top of microwave oven exterior. Lift up damper plate. ..........C........ // '\ c)_ I A. Damper vent covers B. Perforations C. Diagonal wire cutting pliers 4, Rotate blower motor 180 ° so that exhaust ports face the back of microwave oven, and lower blower motor back into the microwave oven. A A. Exhaust port 5. Close damper plate, and reinsert top blower motor screw removed in Step 1 A B B A. Damper plate screw B. Damper plate C. Top blower motor screw 4 i G_% A. Top blower motor screw B. Damper plate