Maytag MOED6030LZ Dimension Guide - Page 3

DIMENSION GUIDE Double Ovens Installed in Cabinet A B D F G E C 30" (76.2 cm) models A. 30" (76.2 cm) minimum cabinet width B. 1" (2.5 cm) top of cutout to bottom of upper cabinet door C. 143⁄4" (37.5 cm) bottom of cutout to floor is recommended 71⁄2"-143⁄4" (19.1 cm-37.5 cm) bottom of cutout to floor is acceptable. D. 281⁄2" (72.4 cm) minimum cutout width E. 11⁄2" (3.8 cm) minimum bottom of cutout to top of cabinet door F. 501⁄4" (127.6 cm)* recommended cutout height G. 24" (60.7 cm) cutout depth *NOTES: ■ The cutout height can be between 50" and 523⁄16" (127 cm and 132.6 cm) for double ovens. ■ Contact service to get tall shield for cutouts greater than 503⁄8" (128 cm) to enhance installation. 3 of 12 Cabinet Dimensions - Double Ovens, Flush Installations NOTES: ■ This is an alternate option to install your product in the cabinet and obtain a flush look. For standard installation, refer section "Product Dimensions - Double Ovens, Standard Installation." ■ On single and double oven models installed above a warming drawer or for ovens installed using flush installation cabinetry, a deflector kit must be installed. See the "Online Ordering" section of your Quick Start Guide for information on ordering. A 253⁄8" (64.4 cm) minimum cutout depth is required. Top and bottom gaps will be 1/8" (0.3 cm) gap above and below the product. Top and bottom gaps not required for installation. Exposed areas of the cabinet should be finished to match. Double Ovens Installed in Cabinet FRONT VIEW SIDE VIEW A B C DE F F G G H H J I 30" (76.2 cm) models A. 3/4" (1.9 cm) top cleat* B. 301⁄4" (76.8 cm) minimum width of flush inset cutout C. 287⁄8" (73.3 cm) minimum width of opening D. 52" (132.1 cm) minimum height of flush inset cutout E. 511⁄4" (130.1 cm) recommended cutout height F. 11/16" (1.7 cm) side cleat* G. 1/4" (0.6 cm) recommended with foot. 15/16" to 11⁄8" (2.2 cm to 2.9 cm) allowable without foot. H. Recommended junction box location I. 45⁄8"-32" (11.7-81.3 cm) bottom of cutout to floor J. 25" (63.5 cm) minimum depth of cutout *Cleats and spacers must be recessed 13⁄8" (3.5 cm) from the front of the cabinet.