Maytag MSD2650KEU Use and Care Manual - Page 7

Installation 3. Place brass nut (A) and sleeve (B) on copper tube end as illustrated. Reminder: Do not use an old sleeve. The nut and sleeve are B provided in the Use and Care A packet. 4. Place end of copper tubing into water valve inlet port. Shape tubing slightly. Do not kink - so B that tubing feeds straight into inlet A port. 5. Slide brass nut over sleeve and screw nut into inlet port. Place adjustable wrench on nut (1) attached to plastic waterline and maintain position. 1 2 Using second adjustable wrench turn the lower nut (2) counterclockwise and fully tighten while holding the upper nut in place. Important: Do not over-tighten. Cross threading may occur. 6. Pull on tubing to confirm connection is secure. Connect tubing to frame with water tubing clamp (C) and turn on water supply. Check for leaks and correct if necessary. Continue to observe the water supply C connection for two to three hours prior to moving the refrigerator to its permanent location. 7. Monitor water connection for 24 hours. Correct leaks, if necessary. Handle Installation If not installed, the handle is located in the interior of the fresh food section or attached to the back of your refrigerator. Remove and discard handle packaging and tape. Handle design varies from refrigerator to refrigerator. Please reference the appropriate instructions for your model. Plastic Handle with Extensions Attach Extensions to Handle: 1. Align handle and extension as shown. 2. Place extension in handle opening. 3. Apply slight pressure to both sides of the extension piece. 4. Slide extension until it stops on inside edge of handle. To Install: 1. The handles are to be oriented as shown. 2. Align door handle with the door studs. 3. Ensure the large hole in the mounting clip is positioned down on both ends of the handle. Door Stud 4. Rotate the handle so that the handle is flat against the door. 5. Grasp the handle firmly and slide down. Cont. 6