Maytag MVWB750WR Installation Instructions - Page 8
Check levelness of washer, Adjust levelness of washer, Plug into a grounded, prong outlet
UPC - 883049185811
View all Maytag MVWB750WR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
3. Check levelness of washer Place level here 4. Adjust levelness of washer Place level here Check the levelness of the washer. First, place a level on the lid near the console. Then place the level on the side of the washer in the crease between the top of the washer and the cabinet. If the washer is not level, move the washer out slightly, tip back and prop up the front of the washer with a wood block. Adjust the right front foot by loosening the locknut with a 9/16" or 14 mm open-end wrench, then twisting the foot up or down as needed.After the washer is level, make sure all 4 feet are in firm contact with the floor by gently rocking it back and forth and side to side. Adjust the feet if necessary, then using the wrench again, turn the locknuts counterclockwise on the foot to tighten to the washer cabinet. HELPFUL TIP: You may have to adjust the back feet to level the washer. If you are installing the washer in a tight or hard to reach area, you may have to move the washer out to reach the feet comfortably. You may wish to lock the back feet before moving the washer back into place. IMPORTANT: If the locknuts are not tight against the washer cabinet, the washer may vibrate. Not Level LEVEL Not Level 5. Plug into a grounded 3 prong outlet 8