Maytag MVWB835DC Installation Guide - Page 10
Make Electrical Connection, U.s.a. Only Effectuer Le, Raccordement Électrique, États-unis Seulement
View all Maytag MVWB835DC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
MAKE ELECTRICAL CONNECTION U.S.A. ONLY (EFFECTUER LE RACCORDEMENT ÉLECTRIQUE - ÉTATS-UNIS SEULEMENT) ELECTRICAL CONNECTION Power Supply Cord 2. Remove terminal block cover Remove hold-down screw and terminal block cover. POWER SUPPLY CORD CONNECTION Power Supply Cord Strain Relief 1. Attach power supply cord strain relief Electrical Connection Options 1. Choose electrical connection type Power supply cord 4-wire receptacle (NEMA Type 14-30R): Go to Power Supply Cord Connection. Power supply cord 3-wire receptacle (NEMA Type 10-30R): Go to Power Supply Cord Connection. A B C D Remove the screws from a 3/4" (19 mm) UL listed strain relief (UL marking on strain relief). Put the tabs of the two clamp sections (C) into the hole below the terminal block opening (B) so that one tab is pointing up (A) and the other is pointing down (D), and hold in place. Tighten strain relief screws just enough to hold the two clamp sections (C) together. 2. Attach power supply cord to strain relief 4-wire direct connection: Go to Direct Wire Connection. 3-wire direct connection: Go to Direct Wire Connection. NOTE: If local codes do not permit connection of a cabinet-ground conductor to neutral wire, go to "Optional 3-wire connection." This connection may be used with either a power supply cord or a direct wire connection. 10 Put power supply cord through the strain relief. Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten strain relief screws at this point.