Maytag MVWC200XW Owners Manual - Page 8

WASHER MAINTENANCE WATER INLET HOSES Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found. When replacing your inlet hoses, mark the date of replacement on the label with a permanent marker. CLEANING YOUR WASHER Keep your washer as clean and fresh as your clothes. To keep washer interior odor-free, follow this recommended monthly cleaning procedure: 1. Make sure the washer is empty. 2. Using recommended AFFRESH® washer cleaner, add one tablet to washer basket OR If using liquid chlorine bleach, add 1 cup (250 mL) to liquid chlorine bleach dispenser. NON-USE AND VACATION CARE Operate your washer only when you are home. If moving, or not using your washer for a period of time, follow these steps: 1. Unplug or disconnect power to washer. 2. Turn off water supply to washer, to avoid flooding due to water pressure surge. WINTER STORAGE CARE IMPORTANT: To avoid damage, install and store washer where it will not freeze. Because some water may stay in hoses, freezing can damage washer. If storing or moving during freezing weather, winterize your washer. To winterize washer: 1. Shut off both water faucets; disconnect and drain water inlet hoses. 2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run washer on RINSE & SPIN cycle for about 30 seconds to mix antifreeze and remaining water. 3. Unplug washer or disconnect power. IMPORTANT: Do not add detergent. Do not use more than recommended amount of bleach to avoid damaging product over time. 3. Close washer lid. 4. Select Heavy Duty Regular cycle, hot Temperature, and large Water Level. 5. Press START/Pause/Unlock. Water will pour into washer for a moment and pause, lid will lock, then cycle will continue. NOTE: For best results, do not interrupt cycle. If cycle must be interrupted, press START/Pause/Unlock twice and run a RINSE & SPIN cycle to ensure bleach has been rinsed from washer. Press and hold the START/Pause/Unlock for 3 seconds to cancel the cycle. Cleaning the liquid fabric softener dispenser 1. Remove dispenser by grasping top with both hands and squeezing, while pushing upward with thumbs. 2. Rinse dispenser under warm water, then replace it. NOTE: To avoid damage to the washer or clothing, do not wash clothes with the liquid fabric softener dispenser removed. Cleaning the bleach dispenser Wipe the inside of the bleach dispenser with a clean, damp cloth. To clean exterior: 1. Use a soft, damp cloth or sponge to wipe up any spills. 2. Use all-purpose surface cleaner, if needed. IMPORTANT: To avoid damaging the washer's finish, do not use abrasive products. 8