Maytag UXI1200DYS Installation Guide - Page 3
Installation Requirements - washer
View all Maytag UXI1200DYS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed ■ Drill ■ 1¼" (3 cm) drill bit 0.5 cm) drill bit ■ Pencil ■ Wire stripper or utility knife ■ Tape measure or ruler ■ Pliers ■ Caulking gun and weatherproof caulking compound ■ Vent clamps ■ Jigsaw or keyhole saw ■ Flat-blade screwdriver ■ Metal snips ■ Phillips screwdriver Parts needed ■ ½" (1.3 cm) UL listed or CSA approved wiring conduit and connectors ■ 6 - 18 AWG wires, one each of the following colors: black, white, red, blue, gray, and green or green/yellow (ground) NOTE: The length of the conduit and 18 AWG wires is determined by the distance between the in-line blower motor and range hood terminal boxes. ■ 11 - UL listed wire connectors ■ ½" (1.3 cm) UL listed or CSA approved strain relief Parts supplied Remove parts from packages. Check that all parts are included. ■ 4 - 6.3 x 60 mm mounting screws ■ 4 - flat washers ■ 6-wire connector assembly for range hood ■ 2 - strain relief connectors ■ 1 - strain relief bushing Location Requirements IMPORTANT: Observe all governing codes and ordinances. Have a qualified technician install the in-line blower motor system. All openings in the ceiling and wall where the in-line blower motor system will be installed must be sealed. For Mobile Home Installations The installation of this in-line blower motor system must conform to the Manufactured Home Construction Safety Standards, Title 24 CFR, Part 328 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280) or when such standard is not applicable, the standard for Manufactured Home Installation 1982 (Manufactured Home Sites, Communities and Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local codes. Product Dimensions Top (outlet) view 24³⁄₄" (62.9 cm) 7⁷⁄₈" (20.0 cm) 3³⁄₈" (8.6 cm) 12 32.9 cm) 14 37.3 cm) Bottom (inlet) view 26¹⁄₈" (66.4 cm) 16¹⁄₈" (41.0 cm) 7⁷⁄₈" (20.0 cm) 3³⁄₈" (8.6 cm) 3