Maytag UXL5430BSS Installation Guide - Page 4
Installation Requirements - washer
View all Maytag UXL5430BSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed ■ Level ■ Drill 3 mm) drill bit ■ Pencil ■ Pliers ■ Tape measure or ruler ■ Caulking gun and weatherproof caulking compound ■ Phillips screwdriver ■ Flat-blade screwdriver ■ Saber or keyhole saw ■ Vent clamps ■ Metal snips Parts needed ■ 6" (15.2 cm) round metal vent system For vented installations, you will need: ■ 1 wall or roof cap For non-vented (recirculating) installations, you will also need: ■ Recirculation Kit Part Number W10490330. See the "Assistance or Service" section to order. Parts supplied Remove parts from packages. Check that all parts are included. ■ Damper ■ Hardware package. Includes: Installation Instructions and Use and Care Guide 2 mounting brackets 6 spacers 10 - 4.5 x 13 mm wood screws 2 - 4.2 x 15 mm machine screws 4 - 3.5 x 9.5 mm flat-head sheet metal screws 8 - 4.2 x 19 mm sheet metal screws 2 - 3.5 x 9.5 mm sheet metal screws 1 - 30" x 12" (76.2 x 30.5 cm) face panel 2 metal grease filters T10 TORX®† adapter 8 - metal washers 8 - plastic washers Location Requirements IMPORTANT: Observe all governing codes and ordinances. Have a qualified technician install the range hood. It is the installer's responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located inside the liner behind the filter on the left wall of the range hood. Range hood location should be away from strong draft areas, such as windows, doors, and strong heating vents. Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance. Consult your cooktop/ range manufacturer installation instructions before making any cutouts. Grounded electrical outlet is required. See "Electrical Requirements" section. The range hood is factory set for vented installations through the roof or wall. For non-vented (recirculating) installations see "NonVented (recirculating) Installation Through the Soffit/Cabinet" in the "Prepare Location" section. Recirculation Kit Part Number W10490330 is available from your dealer or an authorized parts distributor. All openings in ceiling and wall where range hood will be installed must be sealed. For Mobile Home Installations The installation of this range hood must conform to the Manufactured Home Construction Safety Standards, Title 24 CFR, Part 328 (formerly the Federal Standard for Mobile Home Construction and Safety, title 24, HUD, Part 280) or when such standard is not applicable, the standard for Manufactured Home Installation 1982 (Manufactured Home Sites, Communities and Setups) ANSI A225.1/NFPA 501A, or latest edition, or with local codes. †®TORX is a registered trademark of Saturn Fasteners, Inc. 4