Maytag UXT4230ADS Use & Care Guide - Page 10

RANGE HOOD USE The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen. The hood controls are located on the front panel of the range hood. A Range Hood Controls B C A. Incandescent light housing and cover B. Grease filter retainer C. Grease filter A B A. Fan speed switch B. On/Off light switch Operating the light Turn the light switch to the right 1 position for Low (night light). Turn the light switch to the right 2 positions for High. Operating the fan The fan is variable speed. Rotate the fan switch to the right to turn the fan to the On position. Continue to rotate the switch to the desired fan speed. To turn the fan off, rotate the fan speed switch to the left to the Off position. RANGE HOOD CARE Cleaning IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace the grease filter before operating hood. Exterior Surfaces: IMPORTANT: Do not use soap-filled scouring pads, abrasive cleaners, cooktop polishing creme, steel wool, gritty washcloths or paper towels. To avoid damage to the stainless steel, do not use cleaners that contain chlorine. Cleaning Method: ■ Liquid detergent or all-purpose cleaner: Rinse with clean water and dry with a soft, lint-free cloth. Metal or Charcoal Grease Filter To Clean the Filter: 1. Remove the screw from the grease filter retainer. 2. Turn the grease filter retainer to release the filter. A ■ Glass cleaner to remove fingerprints. ■ For stainless steel models, use Stainless Steel Cleaner and Polish, Part Number 31462A (not included): See the "Assistance or Service" section to order. ■ For stainless steel models, rub in the direction of the grain to avoid scratching or damaging the surface. A. Filter retainer 3. For vented installations: Wash the metal filter as needed in a dishwasher or hot detergent solution. For non-vented (recirculating) installations: Replace the metal filter with a charcoal filter. The charcoal filter is not washable. It should last up to 6 months with normal use. For information on ordering, see the "Assistance or Service" section. Dispose of old charcoal filter. To Replace the Filter: 1. To reinstall the filter, place the back edge of the filter into the channel at the rear of the hood. Push the filter into place and turn the filter retainer to secure the filter to the range hood. 2. Replace the screw in the grease filter retainer. 10