Memorex MVDP1085-CHW Manual - Page 44
Troubleshooting Guide
UPC - 749720014170
View all Memorex MVDP1085-CHW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
TROUBLESHOOTING GUIDE Check the following before requesting service: SYMPTOM GENERAL No power. Power on, but unit not functioning properly. POSSIBLE CAUSE Battery pack is empty. Condensation has formed. Wrong type of disc inserted. Unit needs to be reset. POSSIBLE SOLUTION Recharge battery pack. Unplug the unit and wait about one to two hours to allow the player to dry. This unit cannot play discs, other than DVD, standard CDs, MP3 or picture CDs. Unplug from AC and remove battery, wait 10 minutes, then reinsert and try again. No picture. The disc is dirty or inserted incorrectly. Some features and functions are not available on all discs. The equipment is not connected properly. The INPUT of the TV is not set to receive the DVD signal output. The video cables not securely connected. AV IN/OUT switch in the IN position. Clean disc and insert label side-up. This is normal; try another function. Connect the equipment according to the instructions in this manual. Select the appropriate video input mode, usually VIDEO or AV. Connect the video cables securely. Switch the AV IN/OUT to OUT position. No sound. Playback picture rolls. The playback picture is poor. The Search feature is not working. The picture is not fitting properly. The remote control is not working. The equipment is not connected properly. The equipment connected with the audio cable is not set to receive the DVD signal input. The audio cables are not securely connected. The connected receiver's power is off. Unit needs to be reset to NTSC. The disc is dirty. Some discs have sections that do not allow searching. Wrong menu option is selected in the Setup menu. The battery is weak or dead. The battery is not installed properly. The remote is not aimed at the sensor. Distance is too far or there is too much light in the room. There is an obstacle in the path of the beam. Connect the equipment according to the instructions in this manual. Select the appropriate audio input mode. Connect the audio cables securely. Turn the audio receiver on. Set menu option to NTSC. Clean the disc. This is normal on some discs. Select the correct TV type (PS, LB, WIDE) which matches the TV you are using. Install a fresh battery. Install battery according to the diagram. Aim the remote at the sensor. Operate within 20ft, or reduce the light in the room. Move obstacle. 1 43