Metabo SE 12-115 Set Instruction Manual - Page 9

- Press in spindle locking button (8) and hold in place. - Screw the tool fixing screw (15) onto the tensioning spindle and tighten (the spindle locking knob engages and the tool can be secured). If the tools used are shorter than the tensioning spindle, insert the relevant distance sleeves (18). This is the only way to properly secure the tool. 8. Maintenance Disconnect the mains plug or remove the battery pack from the machine before starting any maintenance work. Motor cleaning: blow compressed air through the rear ventilation slots of the machine regularly, frequently and thoroughly. Here, the machine must be held firmly. Mains powered machines: The Autostop carbon brushes must only be replaced in a specialist workshop. Always have checks and maintenance work carried out by Metabo Customer Service. 9. Troubleshooting 9.1 Mains powered machines - Electronic restart protection The red electronic signal indicator (2) starts flashing. If the mains plug is inserted with the machine switched on, or if the current supply is restored following an interruption, the machine does not start up. Switch the machine off and then back on again. - The electronic signal indicator (2) lights up and on-load speed is reduced. Winding temperature too high. Run the machine in idling until the electronics signal indicator switches off. - High-energy, high-frequency interference High-energy, high-frequency interference can cause the machine to deactivate. In this case, please switch off the machine, disconnect the plug and then reinsert. As soon as the interference is reduced, you can continue work. 9.2 Cordless machines - The electronic signal display (2) lights up and the load speed decreases. The temperature is too high! Run the machine in idling until the electronics signal indicator switches off. - The electronic signal display (2) flashes and the machine does not start. The restart protection is active. The machine will not start if the battery pack is inserted while the machine is on. Switch the machine off and on again. ENGLISH en For a complete range of accessories, see www.metabo.com or the catalogue. 11. Repairs Repairs to electrical tools must be carried out by qualified electricians ONLY! If you have Metabo electrical tools that require repairs, please contact your Metabo service centre. For addresses see www.metabo.com. You can download spare parts lists from www.metabo.com. 12. Environmental Protection Observe national regulations on environmentally compatible disposal and on the recycling of disused machines, packaging and accessories. Special instructions for cordless machines: Battery packs must not be disposed of with regular waste. Return faulty or used battery packs to your Metabo dealer! Do not allow battery packs to come into contact with water! Before disposal, discharge the battery pack in the power tool. Prevent the contacts from shortcircuiting (e. g. by protecting them with adhesive tape). 13. Technical specifications Explanation of details on page 3. Subject to changes serving technical progress. D = Permitted wheel diameter MBmax = Maximum wheel width = Spindle thread l = Length of spindle n = No-load speed (maximum speed) U = Voltage of battery pack IPPm11220 V = Current at 120 V = Nominal power input = Power output = Weight with smallest battery pack/weight without cord The technical specifications quoted are subject to tolerances (in compliance with the relevant valid standards). Wear ear protectors! 10. Accessories Use only genuine Metabo accessories. Use only accessories that fulfil the requirements and specifications listed in these operating instructions. 9