Miele DAR 1220 Set 4 Operating instructions/Installation instructions - Page 9

Installation Installation DRIB XL/XXL into the range hood ^ Please refer to the operating and installation instructions supplied with the range hood. Installation DREB XL/XXL on an external wall ^ Feed the exhaust duct c through the wall and secure it to the motor unit fixing bracket with a hose clip. ^ Apply a sealant along the outside edge on the rear wall of the blower housing. ^ Mount the external blower on the external wall using four screws d. If unsure or unfamiliar with these installation procedures, please contact Miele. Select a suitable installation location. - Make sure that there are no supporting elements, electrical or piping in the wall at the selected location. - Install the external blower with the exhaust outlet facing downwards. ^ The external blower must be installed on a level surface. If necessary, remove the wall covering at the installation location. ^ Seal the screw heads. ^ The ducting is then connected to the cooker hood. If using 8" (203 mm) ducting C, insert the reducing collar e supplied into the exhaust connection, and secure the exhaust ducting to the reducing collar with a hose clip. (See "Connection for air extraction"). ^ Place the exhaust ducting on the blower connection f for the ventilation hood. ^ See "Air Extraction" for additional instructions on installation the ducting. ^ Screw the fixing brackets a on the backside of the the blower housing. ^ Make an hole for the exhaust duct and the connecting cable. The external blower DREB XL and the range hood are connected by a 8" (203 mm) exhaust duct C , the external blower DREB XXL by a 10" (254 mm) exhaust duct C (see "Air extraction"). Electrical connection See "Electrical connection" and "Important Safety Iinstructions" before connecting to the electrical supply. ^ Feed the connecting cable b with the six-pole connectors through the wall into the house. 9