Miele G4286 SCVi Product Manual - Page 54

Plumbing Connection to the water supply ,Installation, repairs and other work by unqualified persons could be dangerous. ,Do not drink water from the dishwasher! - Water pressure: Must be between 4.5 - 145 psi (0.3 - 10 bar). - If the water pressure if lower, a "Water Intake" notification will be shown. See "Frequently Asked Questions" for more information. - If the water pressure is higher than shown, a pressure reducing valve must be used. - The dishwasher can heat its own water to the temperature required by the wash program. This allows for connection of the machine to either a hot (max. 140°F / 60°C) or cold water source. For lowest energy consumption you may connect the dishwasher to a cold water source. For fastest possible wash times, with slightly higher energy consumption, connect the dishwasher to a hot water source. - The inlet hose is approximately 5 ft. (1.5 m) long. - The water inlet hose comes equipped with an inlet hose ending with a 3/8" female compression fitting. This can be directly connected to a water supply valve or to an appropriate coupling. Ensure that the water connection is secure after the first use. ,To prevent damage to the dishwasher, it must only be connected to a fully vented drainage system. ,Do not cut the intake hose. If the hose is cut, the dishwasher will not work. There will be a water leak. If the hose is too long, coil it neatly and place it behind or under the machine. If not connected directly to a water supply valve, an appropriate adapter (not included) is required. 54