Miele WWD660 WCS TDos Short user manual - Page 2
Quick Start Guide, Washing machine - 8 kg
View all Miele WWD660 WCS TDos manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Program overview fold here Full load (17.6 lb/8 kg) Max, Med, Slow, Treating microfiber fabric, ski wear, or table linens/drapes made from mainly synthetic fibers to provide a finish which is resistant to water and dirt. Small load (5.5 lb/2.5 kg) Small load (5.5 lb/2.5 kg) Full load (17.6 lb/8 kg) Half load (7.7 lb/3.5 kg) Small load (4.4 lb/2 kg) Small load (4.4 lb/2 kg) Small load (4.4 lb/2 kg) Full load (17.6 lb/8 kg) Small load (6.6 lb/3 kg) Full load (17.6 lb/8 kg) High, Med, Slow, , Performance outerwear (e.g., jackets and pants) made from membrane fabric such as Gore-Tex®, SYMPATEX®, WINDSTOPPER®, etc. Load Med, Slow, , Max, High, , High, Med, Slow, , High, Med, Slow, , Med, Slow, , High, Med, Slow, , Speed Make sure you select the appropriate spin speed. , , Warm+, , Warm+, Warm, Cold For white fabrics made of cotton or linen without special hygiene requirements. Cotton fabrics that have hardly been worn or are only very lightly soiled. Warm+, Warm, Cold The Miele app is used to select programs and operate the appliance. Black and dark garments made from cotton, mixed fibers, and denim. Warm+, Warm, Cold Drain only: set spin speed to . Cold Hot+ Pre-treat collars and cuffs depending on the level of soiling. Hot+, Hot, Warm+, Warm, Cold For delicate fabrics which are only suitable for hand washing. Warm+, Warm, Cold Cotton or linen fabrics with direct skin contact or for which special hygiene requirements apply. Max, High, , Med, Slow, , Max, Sani For delicate fabrics made from synthetic fibers. Hot+, Hot, Warm+, Warm, Cold Cotton, linen, and mixed-fiber fabrics made of both cotton and linen. Hot+, Hot, Warm+, Warm, Cold Temperature Drain/Spin Proofing Outdoor Extra White Express MobileStart Darks/Denims Dress Shirts Handwash Sanitize Delicates Normal Program fold here PROGRAM OVERVIEW fold here fold here Detergent Cleaning and care Detergents recommended by Miele Miele UltraPhase 1 and 2 Normal Delicates Sanitize Handwash - Dress Shirts Darks/Denims Express Extra White Outdoor - Proofing - Miele Capsules - - - - - - - - - - - - - - Recommendation - No recommendation Special-purpose detergents (e.g., WoolCare) Fabric care (e.g., fabric softener) Additives (e.g., booster) Cleaning the detergent drawer Washing at low temperatures and the use of liquid detergent can lead to a build-up of bacteria in the detergent drawer. Clean the entire drawer at regular inter- vals for hygiene reasons, even if you are using the TwinDos system exclusively. Pull out the deter- gent drawer until a resistance is felt. Press down the release button and, at the same time, pull the drawer completely out of the machine. Removing and cleaning the insert for liquid detergents An insert for liquid detergents is located in the compartment of the detergent drawer. Remove the in- sert. Clean the insert thoroughly with warm water. Cleaning the siphon inside the compartment Compartment 1 has a siphon for better dispensing of the chlorine bleach. Remove the re- lease catch. Remove the siphon and clean under warm running water. Cleaning the siphon inside the compartment Remove the siphon from the compartment and clean under warm running water. Clean all compartments with warm wa- ter. Cleaning the detergent-drawer housing Use a bottle brush to remove detergent residues and limescale from the jets inside the detergent-drawer housing. Replace the detergent drawer. Tip: Leave the detergent drawer slightly open to allow it to dry. Sanitize info (cleaning the drum) Washing at low temperatures and/or using liquid detergent can cause bacteria and unpleasant odors to build up in the washing machine. Use the Sanitize program to clean the washing machine. Clean the drum no later than the point at which the indicator light and light up on the time display. fold here Frequently asked questions ... fold here fold here Problem Possible cause and solution The control field remains dark. There is no power to the machine. Check whether the plug is plugged in. Check whether the fuse has tripped. The washing machine has switched off automatically to save energy. Switch the washing machine on again by turning the pro- gram selector. and alternate on the time display. The door is not closed properly. The door lock could not engage. Close the door again. Start the program again. If the fault message appears again, contact Miele Service. After the appliance is switched on, appears on the time display. An update is available for the washing machine. See "Programmable functions RemoteUpdate" for more information. The fault indicator light lights up. and alternate on the time display and the buzzer sounds. The drain is blocked or restricted. The drain hose has been fixed too high. Clean the drain filter and the drain pump. The maximum drain height is 1 m. The fault indicator light lights up. and alternate on the time display and the buzzer sounds. The water intake is blocked or restricted. Check whether the faucet is turned on properly. Check whether the inlet hose is kinked. Check whether there is sufficient water pressure. The filter in the water intake is blocked. Clean the filter. The fault indicator light lights up. and alternate on the time display and the buzzer sounds. The water protection system has reacted. Close the faucet. Contact Miele Service. and alternate on the time display and the buzzer sounds. There is a fault. Disconnect the washing machine from the power supply. Unplug the appliance or switch off the breaker. Wait at least 2 minutes before reconnecting the wash- ing machine to the power supply. Switch the washing machine on again. Restart the program. If the fault message appears again, contact Miele Service. Problem Possible cause and solution lights up on the time The program selector was moved to a different position af- display. ter the program had started. Turn the program selector back to the original position. The indicator light lights up. Excessive foam has built up during washing. Use less detergent next time and follow the manufac- turer's instructions on dosage given on the packaging. The indicator light lights When washing, a wash program using a temperature of up and appears on the Hot+ has not been run for a long time. time display. Run the Sanitize program using the Miele Machine Cleaner or a universal powder detergent. The washing machine is cleaned which prevents bacteria and odor buildup. and alternate on the time display. The SoftSteam option which runs at the end of the program could not be carried out properly. Check whether the washing machine is aligned correctly (see "Installation - Leveling the machine"). Check whether the maximum drain height of 3.3 ft (1 m) has been exceeded. If the fault message appears again, contact Miele Service. The washing machine can still be used, but without the SoftSteam option. The sensor button flashes. The UltraPhase 1 cartridge is empty. Replace the UltraPhase 1 cartridge while the washing machine is switched on. The sensor button flashes. The UltraPhase 2 cartridge is empty. Replace the UltraPhase 2 cartridge while the washing machine is switched on. The indicator light lights TwinDos has not been used for too long a time. It is possi- up and appears on the ble that detergent has dried inside the hoses. time display. Immediately carry out the TwinDos maintenance pro- gram as described in "Cleaning and care - TwinDos maintenance". Quick Start Guide Washing machine This Quick Start Guide is not a substitute for the operating instructions supplied with the appliance! It is essential to familiarize yourself with the washing machine before using it for the first time. Please read the operating instructions carefully and pay particular attention to the IMPORTANT SAFETY INSTRUCTIONS. en-US M.-Nr. 11 622 830 / 02 FREQUENTLY ASKED QUESTIONS ... CLEANING AND CARE fold here fold here fold here fold here fold here