Milwaukee Tool 2606-20 Service Parts List - Page 2
Installing Brush Springs On, A Brush Card Assembly With, Four 4 Brushes
View all Milwaukee Tool 2606-20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
INSTALLING BRUSH SPRINGS ON A BRUSH CARD ASSEMBLY WITH FOUR (4) BRUSHES There are two Right Hand Brush Springs and two Left Hand Brush Springs. Follow the instructions below for proper installation. Black Red Brush Card Assy. Be sure carbon brush is in brush tube with brush shunt moving freely in side groove of tube. L R Place brush spring over post with short leg positioned downward as shown. Be sure spring is completely down with short leg trapped against 'Y' shaped wall on brush card. While holding spring in place, bring the long leg of spring over the brush tube and through rear opening of tube. Position rounded hook of spring in groove on back of carbon brush. Be sure to check for free movement between carbon brush, brush shunt and brush spring. Brush Shunt (4 places) Right Brush Spring (2x) Carbon Brush (4x) Left Brush Spring (2x) Wrong Correct Short leg of spring to the bottom