Milwaukee Tool M12 Multi-Tool Tool Only Operators Manual 1 - Page 4
Operation, Specifications, Assembly
View all Milwaukee Tool M12 Multi-Tool Tool Only manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
SPECIFICATIONS Cat. No 2426-20 Volts 12 DC Battery Type M12™ Charger Type M12™ No Load OPM 5000 - 20,000 Hex Wrench 5 mm Recommended Ambient Operating Temperature 0°F to 125°F ASSEMBLY WARNING Recharge only with the specified for the battery. charger For spe- cific charging instructions, read the operator's manual supplied with your charger and battery. Removing/Inserting the Battery To remove the battery, push in the release buttons and pull the battery pack away from the tool. WARNING Always lock the trigger or the battery pack any time remove the tool is not in use. To insert the battery, slide the pack into the body of the tool. Make sure it latches securely into place. WARNING Only use accessories recommended for this specifically tool. Others may be hazardous. Changing Accessories 1.Remove the battery pack. 2.Place the tool upside down on a flat surface. 3.Use the hex wrench to remove the accessory bolt. 4.Remove the outer flange, any accessories and any adapters (sold separately). 5.Clean bolt, flanges, adapter and accessories of all dirt and debris. 6.Place the adapter (if necessary), accessory, outer flange and bolt onto the tool. Determine the need for an adapter by using the chart. Tighten securely using a hex wrench. Typical Accessory Assemblies * * Accessory Arbor Type Use adapter with this side facing accessory adapter not needed adapter not needed * * * * *Adapters sold as accessories OPERATION WARNING To reduce the risk of injury, keep hands away from the blade and all moving parts. Always remove battery pack before changing or removing accessories. Only use accessories specifically recommended for this tool. Others may be hazardous. To reduce the risk of injury, always wear proper eye protection marked to comply with ANSI Z87.1. When working in dusty situations, wear appropriate respiratory protection or use an OSHA compliant dust extraction solution. Typical Applications A large variety of accessories are available for applications such as sawing/cutting, scraping, and sanding. Sawing/Cutting Install a sawing/cutting blade at an angle easy to use. Properly clamp the workpiece. Set the speed dial to a high speed. Start the tool and allow it to reach full speed. Use moderate pressure to avoid burning or scorching the workpiece. Scraping Install a scraping blade at an angle easy to use. Start the tool and allow it to reach full speed. Use light pressure and a low angle to avoid gouging and damaging the workpiece. 4