Motorola 5440AP User Manual - Page 33

Canopy 400 Series OFDM AP and SM User Guide Table 6: US FCC IDs and Industry Canada Certification Numbers and Covered Configurations FCC ID ABZ89FT7629 --- Industry Canada Cert Number --- 109W-5440 Frequencies Module Antenna, LENS, or Families Reflector 10 MHz channels, centered on 54805710 in 5 MHz increments (within the 5470-5725 MHz U-NII band) 5440 AP 5440 SM 17 dBi connectorized antenna (60° x 5° -3 dB beam width) 17 dBi integrated antenna (18° x 18° -3 dB beam width) 10 MHz channels, centered on 54805595 and 56555710 MHz in 5 MHz increments (within the 5470-5725 MHz U-NII band with 5600-5650 MHz excluded) 5440 AP 5440 SM 17 dBi connectorized antenna (60° x 5° -3 dB beam width) 17 dBi integrated antenna (18° x 18° -3 dB beam width) Maximum Transmitter Output Power 10 dBm 10 dBm 10 dBm 10 dBm 6.2.2 Industry Canada (IC) Notification Industry Canada has not approved these devices for operation in Canada. Until they are approved, they are not available for sale in Canada, and the information in this section is provisional and preliminary. This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Users should be cautioned to take note that in Canada high power radars are allocated as primary users (meaning they have priority) of 5650 - 5850 MHz and these radars could cause interference and/or damage to license-exempt local area networks (LELAN). This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to RSS-210 of Industry Canada. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with these instructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to correct the interference by one or more of the following measures: • Increase the separation between the affected equipment and the unit; • Connect the affected equipment to a power outlet on a different circuit from that which the receiver is connected to; • Consult the dealer and/or experienced radio/TV technician for help. To reduce potential radio interference to other users, the antenna type and its gain should be chosen so its Equivalent Isotropic Radiated Power (EIRP) is not more than that permitted for successful communication. Industry Canada Certification Numbers and the specific configurations covered are listed in Table 6. Version 1, April 2008 Page 33 of 40