Motorola BT5010 BULK User Guide - Page 6

GB 1. Charge your headset Make sure that your Jabra BT5010 headset is fully charged for two hours F before you start using it. Use the AC adapter to charge from a power socket, or charge directly from your PC with the USB cable provided. Use only the ES chargers provided in the box - do not use chargers from any other devices as this might damage your Jabra BT5010. PT Connect your headset as shown in fig 2. When the LED indicator light is solid red, your headset is charging. When the LED indicator light is green, it is fully DE charged. IT 2. Turning your headset on and off NL • Press the on/off/pairing button to turn on your headset (see fig 1). The LED will show the battery status to indicate the Jabra BT5010 is on SU (see section 7). • Press the on/off/pairing button to turn off your headset until you see a NO burst of flashes. SE 3. Pair it with your phone Before you use your Jabra BT5010, you need to pair it with your mobile DK phone. 1. Put the headset in pairing mode GR • Make sure the headset is off. • Press the on/off/pairing button marked solid blue. until the LED indicator light is 2. Set your Bluetooth phone to 'discover' the Jabra BT5010 Follow your phone's instruction guide. This usually involves going to a 'setup,''connect' or 'Bluetooth' menu on your phone and selecting the option to 'discover' or 'add' a Bluetooth device.* (See example from a typical mobile phone in fig 3). 3. Your phone will find the Jabra BT5010 Your phone then asks if you want to pair with it. Accept by pressing 'Yes' or 'OK' on the phone and confirm with the passkey or PIN = 0000 (4 zeros). Your phone will confirm when pairing is complete. In case of unsuccessful pairing, repeat steps 1 to 3. 4. Wear it how you like it GB The Jabra BT5010 is ready to wear on your right ear. If you prefer the left, pull out the earhook and rotate and insert as shown. (See fig 4). F ES For optimal performance, wear the Jabra BT5010 and your mobile phone on the same side of your body or within line of sight. In general, PT you will get better performance when there are no obstructions between your headset and your mobile phone. (See fig 5) DE 5. The sliding boom arm IT The sliding boom arm is used for answering and ending calls, but will also NL give an increased audio quality when extended. To answer an incoming call just extend the boom arm to an open position SU and to end the call slide the boom arm back to a closed position. The Jabra BT5010 can of course be used with the boom arm in both NO positions, but will provide the best audio quality when in the open position. SE 6. How to... DK Answer a call • Tap the answer/end button on your headset to answer a call or GR • Open the sliding boom arm to answer the call End a call • Tap the answer/end button to end an active call or • Close the sliding boom arm to end an active call Make a call • When you make a call from your mobile phone, the call will (subject to phone settings) automatically transfer to your headset. If your phone does not allow this feature, tap on the Jabra BT5010's answer/end button to transfer the call to the headset. Reject a call* • Press the answer/end button when the phone rings to reject an incoming call. Depending on your phone settings, the person who called you will either be forwarded to your voice mail or hear a busy signal.  RELEASE YOUR JABRA Jabra BT5010 Bluetooth headset