Motorola H-700 User Manual - Page 2

H700 Bluetooth® Handsfree Headset IMPORTANT: Be sure to first follow the Quick Start Guide on the reverse side to complete initial setup of your H700. TURNING ON AND OFF To turn your headset on, open the headset boom. The indicator light flashes blue if paired with another device, or is steadily lit in purple if ready to be paired. To turn your headset off, close the headset boom. The indicator light will turn off. To conserve battery power, turn off your headset when you don't plan to use it for WEARING THE HEADSET 1 Open the headset boom, then open the earhook (45 from the headset). 2 Loop the earhook over your ear. 3 Press the headset to your ear. 4 Point the headset boom towards your mouth. Multi-Color Indicator Light CHANGING FOR USE ON OTHER EAR You can wear your H700 headset on your left or right ear. The headset comes ready for the right ear. To change the headset for the left ear: 1 Open the headset boom, then open the earhook (90 from the headset). 2 Gently lift and pull the top of the earhook up and off the upper hinge pin. Then, pull it away to remove it. 3 Flip the headset over. 1 Open Earhook 2 Pull Earhook Up 4 Hook the bottom of the earhook onto the lower hinge pin, then lift and pull the top of the earhook over the upper hinge pin. Hinge Pin CHANGING VOLUME BUTTON ORIENTATION You can also change the orientation of the volume buttons on your headset. 1 Turn the headset power off by closing the headset boom. 2 Press the Call E button until the indicator light becomes steadily lit in purple, then press the Volume button you want to assign as the "volume up" button. Volume Buttons Call Button MAKING CALLS MAKING CALLS CONTINUED Function Make a voice dial call End a call Receive a call Reject a call Redial last call Action Tap the Call button and speak the name after the tone Tap the Call button Open headset boom or tap the Call button (if boom is already open) Press and hold the Call button until you hear a beep Press and hold the Call button until you hear a beep Note: Your H700 supports both Handsfree and Headset Profiles. Accessing call functions depends upon which profile your phone supports. See your phone's user's guide for more information. Function Action Answer a second incoming call Press and hold the Call button (places first call on hold) Toggle between two active calls Press and hold the Call button Join a 3-way call Press and hold both Volume buttons Put an active call on hold or resume a call on hold Press and hold the Call button until you hear a beep Transfer a call from the Open headset boom phone to the headset Disable the indicator light Press and hold both Volume buttons for 3 to 4 seconds Mute or unmute a call Tap both Volume buttons Note: Some features are phone/network dependent. INDICATOR LIGHTS With the Charger Plugged In Indicator Light Headset Status Red (steady) Charging (less than 80% charged) Yellow (steady) Charging (more than 80% charged) Green (steady) Charging complete With No Charger Plugged In Indicator Light Headset Status Off Power off Purple (steady) Pairing mode/ Volume button orientation Red Battery low Blue (10 rapid flashes) Pairing successful Blue (slow pulse) Connected (on a call) Blue (quick flash) Standby (not on call) Note: After 5 minutes of inactivity, the light stops flashing to conserve power, but the headset remains in standby mode. AUDIO TONES The audio tones provide information about your headset status. Audio Ton e Single high tone when pressing Volume button Five rapid high tones repeated every 60 sec. No audio indications; deteriorating quality Ring tone Single high tone Single low tone Dual high/low tone Single high tone Low to high tone Two ascending tones Two descending tones Headset Status Volume at minimum or maximum Low battery Out of range Incoming call Pairing confirmation Voice activation Voice tag not recognized End call Phone network not available Mute enabled Mute disabled