Motorola L702CBT User Guide - Page 60

handset is placed on the charger

Page 60 highlights

7. HELP I cannot pair my mobile phone to the telephone base • Make sure the Bluetooth function of your Bluetooth enabled mobile phone is turned on. See the User's Guide of your mobile phone for more information. • Make sure the cordless handset, corded base and mobile phone are located near each other. • Remove the Motorola L702CBT / L703CBT / L704CBT / L705CBT from your mobile phone's Bluetooth device history list (see the User's Guide of your mobile phone for more information). • Carefully follow the pairing instructions in the User's Guide, make sure that your mobile phone is not connected to any other Bluetooth device(s). • Turn off your mobile phone, and then turn it on again. • Reset the telephone base. Unplug the unit's electrical power. Wait for approximately 15 seconds, and then plug it back in. • Repeat the above suggestions. The icon is not scrolling when the cordless handset is placed on the charger • Handset not properly seated on the charger - readjust the handset on the charger. • Dirty contact - clean the charge contacts by wiping with an alcohol moistened cloth. • Battery is full -charging is not necessary at this time. No dial tone • If there is no base power, check the connections. Reset the phone by unplugging then plugging it back into an electrical outlet. • If the cordless handset batteries are empty, recharge the battery pack for at least 24 hours. • Move the cordless handset closer to the corded base. • Be sure to use only the provided telephone cords. Poor audio quality • If the corded base is too close to electrical appliances, reinforced concrete walls, or metal door frames, move the corded base from these areas. No ring tone • The ringer may be off. • The volume may need to be increased. 60 HELP

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71

60
HELP
7. HELP
I cannot pair my mobile phone to the telephone
base
Make sure the Bluetooth function of your Bluetooth
enabled mobile phone is turned on. See the User's
Guide of your mobile phone for more information.
Make sure the cordless handset, corded base and
mobile phone are located near each other.
Remove the
Motorola L702CBT / L703CBT /
L704CBT / L705CBT
from your mobile phone's
Bluetooth device history list (see the User's Guide
of your mobile phone for more information).
Carefully follow the pairing instructions in the User's
Guide, make sure that your mobile phone is not
connected to any other Bluetooth device(s).
Turn off your mobile phone, and then turn it on
again.
Reset the telephone base. Unplug the unit's
electrical power. Wait for approximately 15
seconds, and then plug it back in.
Repeat the above suggestions.
The
icon is not scrolling when the cordless
handset is placed on the charger
Handset not properly seated on the charger -
readjust the handset on the charger.
Dirty contact - clean the charge contacts by wiping
with an alcohol moistened cloth.
Battery is full -charging is not necessary at this
time.
No dial tone
If there is no base power, check the connections.
Reset the phone by unplugging then plugging it
back into an electrical outlet.
If the cordless handset batteries are empty,
recharge the battery pack for at least 24 hours.
Move the cordless handset closer to the corded
base.
Be sure to use only the provided telephone cords.
Poor audio quality
If the corded base is too close to electrical
appliances, reinforced concrete walls, or metal door
frames, move the corded base from these areas.
No ring tone
The ringer may be off.
The volume may need to be increased.