Motorola P1001 User Guide - Page 20

3.14.3 Three-party conference call 1. During an external call, press INT. Your caller is put on hold. 2. Press VOL+ or REDIAL/VOL- to select the handset you want to call. 3. Press MENU to call the handset. 4. When the other handset answers the intercom call, press MENU on the calling handset to set up the conference call. 5. Press /BACK on any handset to end a three-party conference call and leave the other handset engaged with the caller. NOTE During an external call, pressing /FLASH or the call and set up a conference call. /SPEAKER on any handset will join in 3.15 Setting the dial mode The default dialing mode is suitable for your country and network operator. It is unlikely that you should need to change this setting unless advised to do so. 1. Press MENU and then VOL+ or REDIAL/VOL- to select SETUP BS. 2. Press MENU to select DIAL MODE. 3. Press MENU and then VOL+ or REDIAL/VOL- to select TONE or PULSE. 4. Press MENU to save. NOTE If the pulse mode is selected, press TONE/* to switch from pulse to tone dialing temporarily when dialing out. After the call is ended, the dial mode will change back to pulse. 3.16 Setting the flash time The default flash time is 600MS. It is unlikely that you should need to change this setting unless advised to do so. 1. Press MENU and then VOL+ or REDIAL/VOL- to select SETUP BS. 2. Press MENU and then VOL+ or REDIAL/VOL- to select FLASH TIME. 3. Press MENU and then VOL+ or REDIAL/VOL- to the flash time you want. (8 options are available : 90, 100, 110, 250, 300, 400, 600 and 700MS) 4. Press MENU to save. 3.17 Setting the area code 1. Press MENU and then VOL+ or REDIAL/VOL- to select SETUP BS. 2. Press MENU and then VOL+ or REDIAL/VOL- to select AREA CODE. 3. Press MENU and then enter the area code. 4. Press MENU to save. 20 Using the Phone