Motorola WS2000 Reference Guide - Page 164
Setting Up the Access Control List
View all Motorola WS2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 164 highlights
7-22 WS2000 Wireless Switch System Reference Guide 5. Click the Password button in the cell and the Password Settings screen appears. 1.Select an Authentication Algorithm from the drop-down menu, either MD5 or SHA1. 2.Type in an Authentication Password. 3.Select a Privacy Algorithm from the drop-down menu. The options include: • DES • AES 128-bit 4.Type in a Privacy Password that matches the algorithm. 5.Click Ok, when done. 6. Use the Access pull-down menu to specify read-only (R) access or read/write (RW) access for the community. Read-only access allows a remote device to retrieve switch information, while read/write access also allows a remote device to modify switch settings. 7. Follow the directions for setting up the Access Control List (below). 7.9.2 Setting Up the Access Control List To set up the Access Control list as specified by a range of IP addresses, click the SNMP Access Control button at the bottom of the SNMP Access screen. The SNMP Access Control screen appears: 1. Click the Add button to create a new entry in the Access Control table. 2. Specify the IP address for the user(s) that have access. Enter an IP address only in the Starting IP Address column to specify an address for a single SNMP user. Enter both the Starting IP Address and Ending IP Address columns to specify a range of addresses for SNMP users. 3. Click Ok to save changes and return to the SNMP Access screen.