NEC 4T-B60CJ1U 4T-B Series Setup Guide - Page 26

Initial installation Follow the steps below one by one when using the TV for the first time. Some steps may not be necessary depending on your TV installation and connection.  Connect an antenna cable to the antenna terminal. 1 Cable without a CATV converter  Press on the TV. Cable TV lead-In 2 VHF/UHF antenna 75-ohm coaxial cable (round) Home antenna terminal (75-ohm) To TV antenna Coaxial cable terminal (commercially available) Home antenna terminal (75-ohm) To TV antenna Coaxial cable terminal (commercially available) CABLE HDMI 4 HDMI 3 HDMI 2 H1D(AMRIC) CAAB NLT/E PHHE OAND E- AUDDIIG OTIOAULT E(THT 10/ E1RN 00)E SERVI CE R AUD L VIDEO I OCPOSITE OM USB 2 USB 1 • Connect the antenna cable to the TV using one of the methods in the illustration as shown (1 or 2)  Plug the AC cord into the AC outlet. OM HDMI 3 HDMI 2 HDMI 1(ARC) CAABN LT/E PAHNHDEEO- ATUODADUILIGTOI E(THT 1E01/ RN00 )E SERVICE  Run the initial installation. • Follow the guide on the TV screen to set the following settings. I CO POSITE AUD L HDMI 4 VIDEO R USB 1 USB 2 NOTICE F-type connector should be fingertightened only. When connecting the RF cable to the TV set, do not tighten F-type connector with tools. If tools are used, it may cause damage to your TV set. (The breaking of internal circuit, etc.) F-type connector 75-ohm coaxial cable • Place the TV close to the AC outlet, and keep the power plug within reach. TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE AC CORD CONNECTED. The drawings used throughout this model are based on the 4T-B60CJ1U model. 6