NEC 50016755 E900 User Manual - Page 4

Quick Start - monitors

Get NEC 50016755 - MultiSync E900 Plus PDF manuals and user guides
UPC - 050927215360
View all NEC 50016755 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

Quick Start To attach the MultiSync® E900™ monitor to your system, follow these instructions: 1. Turn off the power to your computer. 2. If necessary, install the display card into your system. For more information, refer to the display card manual. 3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws. For the Mac: Connect the MultiSync E900 Macintosh cable adapter (not included) to the monitor connector on the Macintosh (Figure B.1). Attach the 15-pin mini D-SUB end of the captive signal cable to the MultiSync E900 Macintosh cable adapter on the computer (Figure B.1). Tighten all screws. NOTE: To obtain the MultiSync E900 Macintosh cable adapter, call NEC Technologies at (800) 820-1230. 4. Connect one end of the power cord to the MultiSync E900 monitor and the other end to the power outlet (Figure C.1). 5. Turn on the monitor (Figure D.1) and the computer. NOTE: If you have any problems, please refer to the Troubleshooting section of this User's Manual. Captive Signal Cable Untitled-1 15-pin mini D-SUB Figure A.1 2 4 6/15/98, 1:24 PM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
Quick Start
Figure A.1
2
15-pin mini D-SUB
Captive Signal Cable
To attach the MultiSync
®
E
900
™
monitor to your system, follow these
instructions:
1.
Turn off the power to your computer.
2.
If necessary, install the display card into your system. For more information,
refer to the display card manual.
3.
For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync E
900
Macintosh cable adapter (not
included) to the monitor connector on the Macintosh (Figure B.1). Attach the
15-pin mini D-SUB end of the captive signal cable to the MultiSync E
900
Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE:
To obtain the MultiSync E
900
Macintosh cable adapter, call
NEC Technologies at (800) 820-1230.
4.
Connect one end of the power cord to the MultiSync E
900
monitor and the
other end to the power outlet (Figure C.1).
5.
Turn on the monitor (Figure D.1) and the computer.
NOTE:
If you have any problems, please refer to the
Troubleshooting
section of
this User’s Manual.
Untitled-1
6/15/98, 1:24 PM
4