NEC AS203WMi-BK Users Manual - Page 8
Contents, Quick Start
View all NEC AS203WMi-BK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Contents Your new NEC AccuSync LCD monitor box* should contain the following: • AccuSync LCD monitor with tilt base • Audio Cable • Power Cord • Video Signal Cable (15-pin mini D-SUB male to 15-pin mini D-SUB male) • Setup Manual • Base Stand • Cable Holder Setup Manual Cable Holder Setup Manual Audio Cable Power Cord*1 Video Signal Cable Base Stand * Remember to save your original box and packing material to transport or ship the monitor. *1 Type of power cord included will depend on the where the LCD monitor is to be shipped. Quick Start AccuSync LCD monitor (Base Stand not connected) To attach the Base Stand to the LCD Stand: 1. Attach the Base Stand to the Stand. The locking tabs on the Base Stand should fit into the hole on the Stand (Figure S.1). To attach the AccuSync LCD monitor to your system, follow these instructions: 1. Turn off the power to your computer. 2. For the PC or MAC with DVI digital output: Connect the DVI signal cable (not included) to the connector of the display card in your system (Figure A.1). Tighten all screws. For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A.2). Tighten all screws. For the MAC: Connect the Macintosh cable adapter (not included) to the computer and then attach the 15-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure A.3). Tighten all screws. NOTE: Some Macintosh systems do not require a Macintosh cable adapter. Stand Base Stand Figure S.1 DVI Signal Cable (not included) Figure A.1 Figure A.2 Macintosh Cable Adapter (not included) Figure A.3 English-6