NEC ASLCD200VX AccuSync LCD200VX Users Manual - Page 8

Quick Start -continued Remove Monitor Stand for Mounting To prepare the monitor for alternate mounting purposes: 1. Disconnect all cables. 2. Place hands on each side of the monitor and lift up to the highest position. 3. Place monitor face down on a non-abrasive surface. (Place the screen on a 51 mm/ 2.0 inch platform so that the stand is parallel with the surface.) (Figure S.1). 4. Adjust the stand into a 30 degree angle (Figure S.2). 51 mm Figure S.1 Figure S.2 5. To remove two plastic covers: push the covers away from the stand then push toward the top of the monitor to release. (Figure S.3). Figure S.3 6. Remove the 2 screws connecting the stand at the bottom (#1), then remove the 2 top screws (#2) to release the stand assembly (Figure S.4). The monitor is now ready for mounting in an alternate manner. Figure S.4 7. Reverse this process to reattach stand. NOTE: Use only VESA®-compatible alternative mounting method. (100 mm pitch) Handle with care when removing stand. Caution: please use the attached screws (4 pcs) when mounting. To fulfil the safety requirements the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. The LCD monitor shall only be used with an approved arm (e.g. GS mark). 6 ASLCD200VXmanual062204.p65 6 6/23/04, 8:41 AM