NEC E221N-BK Users Manual - Page 13

English Mount Flexible Arm This LCD monitor is designed for use with a flexible arm. 1. Follow the instructions on how Remove Monitor Stand for Mounting to remove the stand. 2. Use the 4 screws removed from the stand or the specified screws to attach the arm to the monitor (Figure F.1). Caution: Use ONLY the screws (4 pcs) that were removed from the stand or the specified screws (Figure F.1) to avoid damage to the monitor or stand. To meet the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. The LCD monitor should only be used with an approved arm (e.g. TUEV GS mark). NOTE: Tighten all screws (recommended Fasten Force: 98 - 137N•cm). Spring washer Flat washer 12 mm Thickness of Bracket (Arm) 2.0~3.2 mm 100 mm 100 mm Weight of LCD assembly: 3.0 kg (E221N) 3.5 kg (E241N) Figure F.1 Attaching VESA Plate for Thin Client Computer This LCD monitor is designed for mounting a thin client computer by using VESA plate and screws. Make sure to attach the VESA plate by tightening all included screws. For mounting a thin client computer, please refer to the computer's manual. NOTE: Make sure the monitor does not fall after attaching a thin client computer. Do not mount a flexible arm on the VESA plate. Please make sure a thin client computer does not cover ventilation holes on the monitor. Mounting on a thin client computer is the customer's responsibility. VESA plate Screws English-11