NEC GT1150 GT1150/2150 - Page 10

Control Codes Function Code Data POWER ON 02H 00H 00H 00H 00H 02H POWER OFF 02H 01H 00H 00H 00H 03H INPUT SELECT RGB 1 02H 03H 00H 00H 02H 01H 01H 09H INPUT SELECT RGB 2 02H 03H 00H 00H 02H 01H 02H 0AH INPUT SELECT VIDEO 1 02H 03H 00H 00H 02H 01H 06H 0EH INPUT SELECT VIDEO 2 02H 03H 00H 00H 02H 01H 07H 0FH INPUT SELECT S-VIDEO 02H 03H 00H 00H 02H 01H 0BH 13H INPUT SELECT DVI (DIGITAL) 02H 03H 00H 00H 02H 01H 1AH 22H INPUT SELECT DVI (ANALOG) 02H 03H 00H 00H 02H 01H 03H 0BH (GT1150 ONLY) INPUT SELECT PC CARD VIEWER 02H 03H 00H 00H 02H 01H 1FH 27H (GT1150 ONLY) PICTURE MUTE ON 02H 10H 00H 00H 00H 12H PICTURE MUTE OFF 02H 11H 00H 00H 00H 13H SOUND MUTE ON 02H 12H 00H 00H 00H 14H SOUND MUTE OFF 02H 13H 00H 00H 00H 15H ON SCREEN MUTE ON 02H 14H 00H 00H 00H 16H ON SCREEN MUTE OFF 02H 15H 00H 00H 00H 17H Note: Contact your NEC rep for codes not listed Cable Connection Communication Protocol: Baud Rate: 38400 bps Data Length: 8 bits Parity: No Parity Stop Bit: One bit X on/off: None Communications: Full duplex PC Control Connector (D-Sub 9P) To TxD of PC To RxD of PC To GND of PC 12 3 45 67 8 9 To RTS of PC To CTS of PC NOTE1: Pins 1, 4, 6, and 9 are used inside the projector. NOTE2: Jumper "Request to send" and "Clear to Send" together on both ends of the cable to simplify cable connection. NOTE3: For long cable runs it is recommended to set communication speed to 9600 bps in the Setup menu. www.necvisualsystems.com GT1150/2150 Page 10 of 10