NEC M260X M260W : user's manual - Page 124

8. Appendix  Troubleshooting This section helps you resolve problems you may encounter while setting up or using the projector. Indicator Messages Power Indicator Indicator Condition Blinking light Steady light Off Blue 0.5 sec On, 0.5 sec Off 2.5 sec On, 0.5 sec Off Blue Orange Red Status Indicator Projector Condition The main power is off The projector is getting ready to turn on. Note - Wait for a moment. Off Timer is enabled. ­- The projector is turned on. - [NORMAL] is selected for [STANDBY MODE] - [POWER-SAVING] is selected for [STANDBY - MODE] Indicator Condition Projector Condition Note Blinking light Steady light Off Normal or Standby [STANDBY MODE]) ([POWER-SAVING] for - Red 1 cycle (0.5 sec Lamp cover error or lamp housing error Replace the lamp cover or lamp housing correctly. On, 2.5 sec Off) 2 cycle (0.5 sec Temperature error The projector is overheated. Move the projector to On, 0.5 sec Off) a cooler location. 3 cycle (0.5 sec Power error Power unit is not working properly. Contact your On, 0.5 sec Off) dealer. 4 cycle (0.5 sec Fan error Fans will not work correctly. On, 0.5 sec Off) 6 cycle (0.5 sec Lamp error Lamp fails to light. Wait a full minute and then turn On, 0.5 sec Off) on again. 9 cycle (0.5 sec [DYNAMIC CONTRAST] error Dynamic Contrast function is not working properly. On, 0.5 sec Off) Contact your dealer. Both the built-in wired LAN and the wireless LAN can- Orange 1 cycle (0.5 sec On, 2.5 sec Off) Network conflict not be connected to the same network at the same time. To use both built-in wired LAN and wireless LAN at the same time, connect them to different networks. Green Re-firing the lamp (The projector is cooling The projector is re-firing. down.) Wait for a moment. Green Standby ([NORMAL] for [STANDBY MODE]) - Orange CONTROL PANEL LOCK is on. You have pressed cabinet button when Control Panel Lock is on. CONTROL ID error Remote control ID and projector ID are not matched. Lamp Indicator Indicator Condition Off Blinking light Red Steady light Red Green Projector Condition Normal - Lamp has reached its end of life. Lamp replace- Replace the lamp. ment message will be displayed. Lamp has been used beyond its limit. The projector Replace the lamp. will not turn on until the lamp is replaced. [ECO MODE] is set to [AUTO ECO], [ECO1], or - [ECO2] Note Over-Temperature Protection If the temperature inside the projector rises too high, the over-temperature protector will automatically turn off the lamp with the STATUS indicator blinking (2-cycle On and Off.) Should this happen, do the following: • Unplug the power cord after the cooling fans stop. • Move the projector to a cooler location if the room where you are presenting is particularly too warm. • Clean the ventilation holes if they are clogged with dust. • Wait about 60 minutes until the inside of the projector becomes cool enough. 114