NEC M40-AV LCD4020/4620/5220/6520, M40/M46 external control commands - Page 10
Typical procedure example
UPC - 805736018417
View all NEC M40-AV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Bit 5-2 Reserved (Don't care) Bit 1 1:Positive Horizontal sync polarity. 0:Negative Horizontal sync polarity. Bit 0 1:Positive Vertical sync polarity. 0:Negative Vertical sync polarity. H Freq: Horizontal Frequency in unit 0.01kHz V Freq: Vertical Frequency in unit 0.01Hz Ex.) When H Freq is '1''2''A''9' (31h, 32h, 41h, 39h), it means 47.77kHz. 5.5.3 NULL Message Command code STX ETX 'B' 'E' The NULL message returned from the monitor is used in the following cases; A timeout error has occurred. (The default timeout is 10sec.) The monitor receives an unsupported message type. The monitor detects a packet BCC (Block Check Code) error. To tell the controller that the monitor does not have any answer to give to the host (not ready or not expected) Complete "NULL Message" command packet as follows; 01h-30h-30h-41h-41h-30h-34h-02h-42h-45h-03h-CHK-0Dh SOH-'0'-'0'-'A'-'A'-'0'-'4'-STX-'B'-'E'-ETX-CHK- CR 6. Typical procedure example The following is a sample of procedures to control the monitor, these are examples of "Get parameter", "Set parameter" and "Save current settings". 6.1. How to change the "Brightness" setting. Step 1. The controller requests the Monitor to reply with the current brightness setting and capability to support this operation. (Get parameter) Header Message SOH-'0'-Monitor ID-'0'-'C'-'0'-'6' STX-'0'-'0'-'1'-'0'-ETX Check code BCC Delimiter CR Header SOH (01h): Start Of Header '0' (30h): Reserved Monitor ID: Specify the Monitor ID from which you want to get a value. Ex.) If Monitor ID is '1', specify 'A'. '0' (30h): Message sender is the controller. 'C' (43h): Message type is "Get parameter command". '0'-'6' (30h, 36h): Message length is 6 bytes. Message STX (02h): Start of Message '0'-'0' (30h, 30h): Operation code page number is 0. '1'-'0' (31h, 30h): Operation code is 10h (in the OP code page 0). ETX (03h): End of Message Check code BCC: Block Check Code Refer to the section 4.5 "Check code" for a BCC calculation. (10/40)