NEC MT1020 MT820/MT1020 - Page 8

1 INTRODUCTION This section introduces you to your new MultiSync MT1020 (XGA)/MT820 (SVGA) LCD Projector, provides a list of materials that comes with your projector and describes the features and controls. Congratulations On Your Purchase Of The MultiSync MT1020/MT820 LCD Projector The MultiSync MT1020/MT820 is one of the very best LCD projectors available today. The multiple LCD panels enable you to project precise images up to 300 inches across (measured diagonally) from your PC or Macintosh computer (desktop or notebook), VCR, document camera, or even a laser disc player. You can use the projector on a tabletop or cart, you can permanently mount it on a ceiling*1, or you can use MultiSync MT1020/MT820 LCD Projector to project images from behind the screen. The remote 13 control can be used wirelessly or with a cable, and you can even use the remote control with the remote mouse receiver to operate the mouse on your PC or Mac. But best of all, the MultiSync MT1020/ MT820 is an NEC LCD projector. That means you can depend on years of reliable performance and crystal-clear presentations! The features you'll enjoy include: • Simple set up and operation. • A high-performance 250 watt metal halide lamp that delivers 700 ANSI lumens (MT1020: 600 ANSI lumens) and is guaranteed for 2000 hours of service or six months, whichever comes first. • A wireless remote control that operates the projector from any angle. • A laser pointer that' s built into the remote control. • The power zoom control enables you to adjust the image to be between 20 and 300 inches (measured diagonally). • You can choose between video modes depending on your source: "normal" for a typical picture, "natural" for true color reproduction, and "camera" for use with a document camera or low APL picture. • The "image capture" enables you to use the entire picture as a background image or to create an image loop. • An image can be projected from in front or behind a screen, and the projector can even be installed on the ceiling. • Supports most IBM VGA, S-VGA, XGA*2, SXGA(pseudo)*3, Macintosh, or any other RGB signals within a horizontal frequency range of 15.754 to 85 kHz (MT820: 15.754 to 60 kHz) and a vertical frequency range of 50 to 85 Hz. This includes NTSC, PAL, SECAM and NTSC4.43 standard video signals. Note: Composite video standards are as follows: NTSC: U.S. TV standard for video in U.S. and Canada. PAL: TV standard used in western Europe SECAM: TV standard used in France and Eastern Europe NTSC4.43: TV standard used in Middle East countries • The remote control can be used with or without a cable, and you can even use the remote to operate your PC or Macintosh mouse wirelessly from across the room with the remote mouse receiver. • You can control your MultiSync MT1020/MT820 LCD Projector with a PC. • The contemporary cabinet design is compact, easy to carry, and complements any office, board room or auditorium. *1 Installing the MultiSync MT1020/MT820 LCD Projector on the ceiling must be done by authorized NEC technicians. C o n s u l t your NEC dealer for more information. *2 An XGA image (1028‫ן‬768) is commpressed into 800‫ן‬600 on MT820. *3 An SXGA pseudo image (1280‫ן‬1024) is not supported by MT820. INTRODUCTION 14