NEC NC2402ML NP-02HD User Manual - Page 47

4-2. Table of adjustment menus 4. Using Menus Menus in parentheses are menus for our service personnel. Normally, these menus cannot be used. Main menu Title Select Configuration Submenu "Title Memory Name" TEST Pattern Light Setup Adjust Lens Control Lens Position Focus Zoom Reset (FactoryDefault) (Setup) Filter Cleaning (Fan Usage) (Light) (Phosphor) (Diffuser) (Pump) (Douser Count) Douser Setup Panel Key Lock Auto Key Lock 3D Reference Off Timer Message Silent Mode Installation (Note) (Option Slot) (Orientation) Lens Type (Note) Lens Calibrate (Note) Lens Center (Note) (Baudrate) (Date/Time) (Fan Speed Mode) (Service) (Title Setup) (Memory) Preset Button (LD Calibrate) Light Lens Preset Button 1-16 Description Reference page Selects the title of the signal to be projected. 49 Selects the test pattern to be projected. 49 Adjusts light brightness. 50 Adjusts the position of the projected screen. 50 Adjusts the size and focus of the projected screen. 50 Returns the settings to their default values. Selects between preset buttons - and titles only, LAN settings only and all settings. Initializes the air filter usage time (for confirming the filter cleaning time). 50 Initializes the usage time of the fan. - Initializes the usage time of the light source. - Initializes the usage time of the phosphor. - Initializes the usage time of the diffuser. - Reset the pump usage time. 53 Resets the number of times the douser has been used. - Sets the douser open/close state. - Locks the buttons on the projector's control panel so that they cannot be - operated. Enables or disables Auto Key Lock. - Sets the signal input terminal for a 3D image system (3D terminal or GPI/O - terminal). Sets the video input port for 3D video systems. Sets the time until the projector power is turned off automatically. - Sets the time to display the message indicating the light replacement cycle, - air filter replacement cycle, and air filter cleaning cycle. Selects whether to use the status indicator, buzzer, indicators on the control - panel and backlight. Configures the device installed in slot (only when the projector is in - standby mode). Sets the projection method and cooling fan operating mode. - This function cannot be used. 51 Performs calibration on lens that support the lens memory function (only 51 when the projector power is turned on). Moves the lens shift position to the center (only when the projector power is 51 turned on). Sets the PC control connector (RS-232) data transmission speed (bps). - Sets the date and time on the projector. - Sets the cooling fan operating mode. - (Only when the projector is in standby mode) - This is used during shadow adjustment and lens mount adjustment (focus balance adjustment). Performs calibration of the light module when the light module has been - replaced (only when the projector power is turned on). The content of the selected light memory (light output power value) can be - overwritten with the current settings. The content of the selected lens memory can be overwritten with the current - settings. Sets the title to be assigned to the preset buttons ( to buttons). 52 47