NEC NP-VE303X Users Manual - Page 22

Introduction Using the Downloadable Software Using the Computer Cable (VGA) to Operate the Projector (Virtual Remote Tool)  When "Computer IN"is selected for Using the utility software "Virtual Remote Tool" that you can input, the Virtual download from our web site (http://www.nec-display.com/ Remote screen or dl/en/index.html), Virtual Remote screen (or toolbar) can be the toolbar will be displayed on your computer screen. displayed as well as your computer screen. This will help you perform operations such as projector's power on or off and signal selection via the computer cable  Use the supplied computer cable (VGA) or serial cable. (VGA) to connect the COMPUTER IN connector directly with the monitor output connector of the computer to use Virtual Remote Tool. Using a switcher or other cables than the supplied computer cable (VGA) may cause failure in signal Virtual Remote screen Toolbar communication. VGA cable connector: Pin This section provides an outline of preparation for use of Nos. 12 and 15 are Virtual Remote Tool. required for DDC/CI. For information on how to use Virtual Remote Tool, see Help  Virtual Remote of Virtual Remote Tool. Please refer to page 19. Tool may not work depending on your computer's Step 1: Install Virtual Remote Tool on the computer. Please refer to page 16. specifications and version of graphic adapters or drivers. Step 2: Connect the projector to the computer. Please refer to page 17. Step 3: Start Virtual Remote Tool. Please refer to page 18. TIP: • Virtual Remote Tool can be used with a serial connection. • For update information on Virtual Remote Tool, visit our website: http://www.nec-display.com/dl/en/index.html • The projector's COMPUTER IN connector supports DDC/CI (Display Data Channel Command Interface). DDC/CI is a standard interface for bidirectional communication between display/projector and computer. 15 ... English