NEC PX-42VP4A 42VP4/42VP4D - Page 10

Rear View/ Terminal Board VIDEO VIDEO 2 VIDEO 1 ( I N / OUT) L (MONO) L (MONO) L (MONO) VIDEO 3 C D E F G H I J K REMOTE External Control OUT IN DV I ( Digital RGB ) RGB 1 (IN / OUT) Cb/Pb Cr/Pr VD Cb/Pb HD Y Cr/Pr R Y AUDIO 3 R B/ G/ R/ R RGB 3 RGB2 / DVD2 / HD2 AUDIO 2 DVD1 / HD1 AUDIO 1 AC IN RIGHT LEFT SPEAKERS MUST HAVE MORE THAN 7WATT RATING IMPEDANCE 6 OHM AC IN RIGHT LEFT SPEAKERS MUST HAVE MORE THAN 7WATT RATING IMPEDANCE 6 OHM A B A AC IN Connect the included power cord here. B Connect speakers (optional) here. Maintain the correct polarity. Please refer to your speaker's owner's manual. C VIDEO1, 2, 3 (BNC, RCA, S-Video) Connect VCR's, DVD's or Video Cameras, etc. here. VIDEO1 can be used for Input or Output (see page 10). D AUDIO1, AUDIO2, AUDIO3 These are audio input terminals. The input is selectable. Set which video image to allot them from the audio menu screen. E DVD1 / HD1 Connect DVD's, High Definition or Laser Discs, etc. here. F RGB2/ DVD2/ HD2 RGB2: You can connect an analog RGB signal and the syncronization signal. DVD2/ HD2: You can connect DVDs, High Definition sources, Laser Discs, etc. here. This input can be set for use with an RGB or component source. (see page 24) G RGB1 (mini D-Sub 15pin) Connect an analog RGB signal from a computer, etc. here. This input can be used for Input or Output. (see page 10) H RGB3 (DVI 24pin) Connect a digital signal (TMDS) from a source with a DVI output. (see page 8) I EXTERNAL CONTROL This terminal is used when operating and controlling the monitor externally (by external control). J REMOTE IN Connect the remote cable* to the remote control's remote jack to obtain wired remote control. K REMOTE OUT Connect the remote cable* to the REMOTE IN jack of the other display monitor to obtain wired remote control. * The 1/8 Stereo Mini cable must be purchased separately. 3