NEC V754Q External Controls - Page 97
Firmware Version
View all NEC V754Q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
18. Firmware Version 18.1 Firmware Version Read This command is used in order to read a firmware version (FIRMWARE REVISION). 1) The controller requests the monitor to reply a firmware version. Header SOH-'0'-Monitor ID- '0'-'A'-'0'-'8' Message STX-'C'-'A'-'0'-'2'-TY-ETX Check code BCC Delimiter CR Header SOH (01h): Start of Header '0' (30h): Reserved Monitor ID: Specify the Monitor ID of which you want to change a setting. Ex.) If Monitor ID is '1', specify 'A'. '0' (30h): Message sender is the controller. 'A' (41h): Message type is "Command". '0'-'8'(30h, 38h): Message length (8bytes) Message STX (02h): Start of Message 'C'-'A'-'0'-'2' (43h, 41h, 30h, 32h): Firmware Version Command TY: Firmware Type Firmware: 00h (30h, 30h) ETX (03h): End of Message Check code BCC: Block Check Code Refer to the section 4.3 "Check code" for a BCC calculation. Delimiter CR (0Dh): End of packet 2) The monitor replies a firmware version to the controller. Header SOH-'0'-Monitor ID- '0'-'B'-'1'-'1' Message STX-'C'-B'-'0'-'2'-ST-TY-MV- PP-BV1-BV2-BV3-BR1-BR2-ETX Check code BCC Delimiter CR Header SOH (01h): Start of Header '0' (30h): Reserved '0' (30h): Message receiver is the controller. Monitor ID: Indicate a replying Monitor ID. Ex.) When this byte is set to 'A', replying monitor's ID is '1'. 'B' (42h): Message type is "Command reply". '1'-'1'(31h, 31h): Message length (17bytes) Message STX (02h): Start of Message 'C'-'B'-'0'-'2' (43h, 42h, 30h, 32h): Firmware Version Read reply ST: Error Status No Error : 00h (30h, 30h) Error : 01h (30h, 31h) TY: Firmware Type Firmware : 00h (30h, 30h) MV: Major Version: 00h (30h, 30h) - 09h (30h, 39h) PP: Period: 2Eh (32h, 45h) (fixed) BV1: Minor (Basic) Version1: (97/145)