NEC V984Q Users Manual - English - Page 17

English Setup 1. Determine the installation location CAUTION • Installing your monitor must be done by a qualified technician. Contact your supplier for more information. • MOVING OR INSTALLING THE MONITOR MUST BE DONE BY FOUR OR MORE PEOPLE. Failure to follow this caution may result in injury if the LCD monitor falls. • Do not mount or operate the monitor upside down. NOTE: This monitor has internal temperature sensors and cooling fans, including a fan for the Option Board. If the monitor becomes too hot, the cooling fans will turn on automatically. The Option Board's fan is active although the temperature is lower than normal operating temperature for cooling the Option Board. If the monitor becomes overheated while the cooling fan is running, a "Caution" warning appears. If the "Caution" warning appears, stop using the unit, turn off the power and allow it to cool. Using the cooling fans will reduce the likelihood of early unit failure and may help reduce image degradation and "Image Persistance". CAUTION: If the monitor is used in an enclosed area or if the LCD panel is covered with a protective screen, please check the inside temperature of the monitor by using the "HEAT STATUS" control in the OSD (see page 41). If the temperature is higher than the normal operating temperature, please turn the cooling fan to ON within the FAN CONTROL menu within the OSD (see page 41). IMPORTANT: To avoid scratching the LCD panel, always place a soft cloth, such as a blanket that is larger than the monitor's screen area, on the table before laying the monitor face down. 2. Install the remote control batteries The remote control is powered by two 1.5V AAA batteries. To install or replace batteries: NEC recommends the following battery use: • Place "AAA" size batteries matching the (+) and (-) signs on each battery to the (+) and (-) signs of the battery compartment. • Do not mix battery brands. • Do not combine new and old batteries. This can shorten battery life or cause liquid leakage of batteries. • Remove dead batteries immediately to prevent battery acid from leaking into the battery compartment. • Do not touch exposed battery acid, it may injure your skin. NOTE: If you do not intend to use the Remote Control for a long period of time, remove the batteries. 3. Connect external equipment (See page 17, page 18 and page 19) • To protect the external equipment, turn off the main power before making connections. • Refer to the user's manual of your equipment for further information. NOTE: Do not connect/disconnect cables when turning on the monitor or other external equipment, as this may result in a loss of the monitor image. 4. Connect the supplied power cord • The monitor should be installed close to an easily accessible power outlet. • Fasten the power cord to the monitor by attaching the screw and clamp. (Recommended Fasten Force: 139 - 189N•cm). • Fully insert the prongs into the power outlet socket. A loose connection may cause image instability and may pose a fire hazard. NOTE: Please refer to the "Important Information" section of this user's manual for proper selection of an AC power cord. A. Press and slide to open the cover. B. Align the batteries according to the (+) and (-) indications inside the case. C. Replace the cover. CAUTION: Incorrect usage of batteries can result in leaks or bursting. Screw Clamp English-15