NEC VT540G User Manual - Page 11

SOURCE Terminal Panel Features RGB INPUT AUDIO 1 3 IN OUT OUTPUT OUT IN 2 4 PC-CONTROL S-VIDEO VIDEO 7 5 ON/STAND BY 8 Slot for Kensington MicroSaver Security System CANCEL STATPUOSWER AUTO ADJUST SELECT ENTER MENU 6 1. RGB Input Connector(Mini D-Sub 15 pin) Connect your PC or other RGB equipment. Use the supplied signal cable to connect to a PC. 2. RGB Monitor Output Connector (Mini D-Sub 15 pin) You can use this connector to loop your computer image to an external monitor from the RGB input source. 3. Audio Input / Output Mini Jack This is where you connect audio output from your computer. Or connect additional external speakers here to listen to audio coming from your Video or S- Video input. 4. Audio Input / Output Connector (RCA) This is where you connect audio output from a VCR, DVD player, or laser disc player. Or connect additional external speakers to listen to audio coming from your RGB source. NOTE: Either connector 3 or 4 can be used for input or output, however they cannot both be used for input simultaneously. It can damage your equipment. 5. Video Input (RCA) Connect a VCR, DVD player, laser disc player, or document camera here to project video. 6. S-Video Input Port (Mini DIN 4 Pin) Connect the S-Video input from an external source like a VCR. 7. PC Control Port (Mini DIN 8 Pin) Use this port to connect your PC to control your projector. This enables you to use your PC and serial communication protocol to control the projector. If you are writing your own program, typical PC control codes are on page E-40. A cap is put on the port at the factory. Remove the cap when using the port. 8. Built-in Security Slot ( ) This security slot supports the MicroSaver ® Security System. MicroSaver ® is a registered trademark of Kensington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc. E-11