NEC X401S Installation Guide - Page 9

Control Codes, Cable Connection - pc

Get NEC X401S PDF manuals and user guides View all NEC X401S manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

X401S Installation Guide 40" LCD Display Control Codes: NEC Display Solutions of America, Inc. Rev 1.0 NOTE: Contact your NEC rep for codes not listed. NOTE: Use a cross/reverse/null modem cable. Cable Connection: Communication Protocol: Interface: RS-232C Communication: Asynchronous Baud Rate: 9600 bps Data Length: 8 bits Parity: None Stop Bit: 1 bit Communication Code: Hex PC Control Connector (D-Sub 9P) NOTE: If so desired, jumper "Request to send" and "Clear to Send" together on both ends of the cable to simplify cable connection. These connections are not required. The only connections required are pins 2 (TxD), 3 (RxD) and 5 (GND). www.necdisplay.com X401S Page 9 of 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
NEC Display Solutions of America, Inc.
X401S Installation Guide
40” LCD Display
Rev 1.0
www.necdisplay.com
X401S
Page 9 of 9
Control Codes:
NOTE:
Contact your NEC rep for codes not listed.
NOTE:
Use a cross/reverse/null modem cable.
Cable Connection:
Communication Protocol:
Interface:
RS-232C
Parity:
None
Communication:
Asynchronous
Stop Bit:
1 bit
Baud Rate:
9600 bps
Communication Code: Hex
Data Length:
8 bits
PC Control Connector (D-Sub 9P)
NOTE:
If so desired, jumper “Request to send” and “Clear to Send” together on both ends of the cable to simplify cable connection.
These connections are not required. The only connections required are pins 2 (TxD), 3 (RxD) and 5 (GND).