NEC X461UN Users Manual - Page 8

Attaching Mounting Accessories The display is designed for use with the VESA mounting system. 1. Attach Mounting Accessories Be careful to avoid tipping monitor when attaching accessories. VESA Mounting Interface 3. Ventilation Requirements When mounting in an enclosed space or recessed area, leave adequate room between the monitor and the enclosure to allow heat to disperse, as shown below. For NEC mounting accessory only Mounting accessories can be attached with the monitor in the face down position. To avoid damaging the screen face, place the protective sheet on the table underneath the LCD. The protective sheet was wrapped around the LCD in the original packaging. Make sure there is nothing on the table that can damage the monitor. When using mounting accessories other than NEC compliant and approved, they must comply with the VESAcompatible mounting method. 2. Installing and removing optional table top stand CAUTION: Installing and removing the stand must be done by two or more people. To install, follow those instructions included with the stand or mounting apparatus. Use only those devices recommended by the manufacturer. Handle with care when mounting LCD monitor stand and avoid pinching your fingers. Optional table top stand Allow adequate ventilation or provide air conditioning around the monitor, so that heat can properly dissipate away from the unit and mounting apparatus; especially when you use monitors in multiple screen. 4. Prevent Tipping When using the display with the Tabletop Stand fasten the LCD to a wall using a cord or chain that can support the weight of the monitor in order to prevent the monitor from falling. Fasten the cord or chain to the monitor using the provided clamp and screw. 304 mm Screw Holes Clamp Cord or chain Screw Before attaching the LCD monitor to the wall, make sure that the wall can support the weight of the monitor. Be sure to remove the cord or chain from the wall before moving the LCD. Table Protective Sheet NOTE: Place stand onto monitor so that the long end of the feet are in the front. English-6