NaceCare TGB516NX Owners Manual for TGB516NX - Page 8

Setting the Cleaning Controls On / Off A B Trigger Trigger To check the battery level pull one of the Triggers or press button (A). To start the brush with the configured water and vacuum C settings pull either trigger and press the Start switch (A). Note: that the start switch (A) must be pressed after the trigger is pulled. The running state of the vacuum and water can be adjusted with or without the brush running. First pull one of the triggers then press the vacuum and water buttons to set the desired operation .These states will be stored for use when the machine is restarted. When the Triggers are released the brush motor and the cleaning solution pump will switch off, the vacuum motor will continue for 10 seconds. D To Enable /Disable Vacuum press button (D). Note: that the vacuum can only be stopped by pressing the vacuum button (D) pulling the triggers will have no effect. The panel if unused, will automatically turn off after 60 seconds. System Error Indicators In the event of a fault the battery lights (F) will flash and the unit will stop operating. The lights will flash a number of times then pause. The number of flashes can be used to identify the fault. F 1) Battery Low 2) Battery over temperature 3) Battery communications error 4) Control board over temperature 5) System power exceeded 6) Vacuum overload 7) Brush overload 8) Control board failed Releasing the handle triggers will allow the machine to reset. ! IMPORTANT If the brush motor keeps overloading consider using a different type of brush. Heavy brush load decreases the available battery run time. ! 7 www.numatic.co.uk