Nady DKW-DUO Manual for - Page 4

WLT Bodypack Transmitter 1. Snap open the BATTERY COMPARTMENT (12) and insert a fresh 9V BATTERY (13), observing the correct polarity. Close the compartment. 2. The WLT is provided with a 3.5 mm LOCKING JACK (14) for connecting the microphone. Plug in the supplied LAVALIER/ LAPEL MICROPHONE (15). To secure the connection, turn the metal slip ring on the plug clockwise to thread it on to the jack. To unplug, reverse the process. Slip the transmitter into a pocket or clip on to your clothes. To use the lavalier mic, attach it at chest level. Do not place too close to the mouth-a distance of about six inches usually works best. To use the headworn mic, place it on the head and adjust the mic boom so that the mic is about one inch to the side of the front of the mouth. (Note: The lavalier/lapel mic wire is also the transmit antenna, and rolling up or shortening the wire may reduce the effective operating range. Extend the wire fully during use, and keep it as straight as possible.) 4. The microphone is now ready to use. When ready to speak, slide the transmitter switch to the On position and adjust the volume of the receiver as per the previous Receiver Operation section. For optimum performance, an INPUT LEVEL CONTROL (18) is provided on the top panel of the WLT. Adjust the gain by turning the control with a small slot head screwdriver. It is recommended that this control be turned to maximum gain. (Note: Observe care in selecting P.A. volume, transmitter location and speaker placement so that acoustic feedback (howling and screeching) will be avoided. Omnidirectional mics pick up sound equally from all directions and are prone to feedback if not used carefully. Mics that are farther from the sound source, such as lavaliers, require more acoustic gain and thus are prone to feedback.) (Note: Microphone elements can easily be destroyed by the buildup of salts and minerals from perspiration and saliva. It is good practice to put a windscreen on the mic element at all times to protect it.) 3. Turn on the WLT by sliding the OFF/ STANDBY/ON SWITCH (16) to the Standby position (transmitter on, audio muted) or the On position (transmitter and audio both on). The BATTERY INDICATOR LED (17) will give a single quick flash, indicating usable battery strength. In the case of a dead or low battery, the LED either will not go on at all or will stay on continuously, indicating that the battery should be replaced with a fresh one. 4