Nady DigiComp 16 Manual - Page 10
Mono In, Stereo In - Stereo Out, Interfacing to a Mixing Console, Using Inserts, LEFT 12, RIGHT
View all Nady DigiComp 16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
• Mono In, Stereo Out While still using the LEFT (12) mono input, connect two audio cables from the LEFT (10) and RIGHT (11) OUPUTS of the DigiComp 16 to a stereo amplification system or two mixer inputs. • Stereo Connect two audio cables to the LEFT (12) and RIGHT INPUTS (13) of the DigiComp 16 from a stereo source, and two other audio cables from the LEFT (10) and RIGHT (11) OUPUTS of the DigiComp 16 to a stereo amplification system or two mixer inputs. Interfacing to a Mixing Console - The DigiComp 16 can accept mono or stereo sends at all system levels. The input circuitry of the DigiComp 16 can easily accept professional +8/9 dBu levels while having enough input and output gain to interface with the low signal levels of home recording systems. The DigiComp 16 may be connected to a mixing console connecting the unit directly to the channel insert socket of a single channel that is to be processed. Another way of interfacing the DigiComp 16 to a mixer or recording console would be in-line between the output of the mixing console and the input of a tape deck or power amplifier. This last setup would be used only if you wanted to process the entire mix. Using Inserts - In the figure below, the situation is described in which the DigiComp 16 applies the desired dynamic process to single instrument signals; in this case, you must use a mixer that features individual channel inserts. 10 Insert jacks on the back of a mixer provide a way of "inserting" external processing equipment into the signal path. The insert occurs after the input amplifier, and before the channel fader; essentially it is the same as connecting the source (instrument or mic) into the DigiComp 16 before the mixer's channel input. Usually, insert connections require a special, stereo-splitting Y-cord. This Y-cord has a stereo 1/4" TRS jack that plugs into the mixer's channel insert socket, and two mono 1/4" TRS jacks (input and output) that will plug into the DigiComp 16. This kind of adapter cord will virtually insert the compression processing into one mixer's channel. Carefully adjust the DigiComp 16 input and output levels in order to satisfy the dynamic requirements of both the processed channels. If you don't hear anything, try to swap the Input and Output ends of the TRS cable plugged into the DigiComp 16. Do not use the effects send/return connections found on most mixers for effect modules, as this could result in heavy frequency response alterations. Mono In If you only want to use the DigiComp 16 for a mono input signal and to connect both of its outputs back to the mixer, you will need three audio cables. Connect a channel insert from the console to the LEFT mono input of the DigiComp 16 via TRS, and another audio cable from the LEFT or RIGHT output of the DigiComp 16 to an adjacent mixer input. Stereo In - Stereo Out This connection is similar to the one described above. However, by utilizing two TRS cables and the console channel inserts, you can process two signals or a stereo signal (e.g., from a keyboard). This operational mode is the one used with the algorithms (1 to 8), designed to process audio stereo sources such as CD's. Improper level setting when using a dynamic processor is the most common cause of noise and distortion problems, so always be careful to ensure optimum audio. 11