Nady FL-10 Manual - Page 2

• The RES (Resonance) (6) knob adjusts the amount of the resonance (feedback). Turn clockwise for increasing the emphasis and characteristic effect of the flanger sound. • The LED INDICATOR (7) lights when the effect is on. This also serves as the battery check, so when it dims, replace the battery. • The FOOTSWITCH (8) - switches between the effect and the unaltered signal with each press. When the effect is on, the LED (7) will light. Using the FL-10 with Other Effects Place the following effects BEFORE the FL-10: Wah-Wah, Envelope Follower, Compression, Distortion Place the following effects AFTER the FL-10: Reverb, Delay, EQ Note: For best sound, all effects placed before the FL-10 should be set at unity gain with the signal from the instrument. Specifications Input Impedance ...1 M Ω Nominal Input Level ...-20dBu Nominal Output Level ...-20dBu Output Impedance ...1 K Ω Recommended Load Impedance 10 KΩ Residual Noise Level (A-weighted 90 dBu typical Delay Time ...0.3mS - 14.5mS LFO Speed ...100mS-20S Controls ..... ON/OFF Footswitch, MANUAL Control, RES (Resonance) DEPT Control, RATE Control Indicator LED (lights when effect is on. When dim, replace the battery) Connectors INSTRUMENT IN Jack, OUTPUT Jack, AC ADAPTER Jack (9VDC) Battery ...9V Alkaline AC Adapter PAD-1 (9VDC), optional Battery Life 10 hours nominal, alkaline battery, varies depending on conditions of use. Dimensions ...5.88" x 3.88" x 2.1" Weight (w/o battery) ...0.90 lbs Specifications subject to change without prior notice. Introduction Congratulations, you have purchased one the finest effects petals available. Thanks for choosing NADY. • Updated classic flanger design produces thickest flanging available • Versatile Manual, Rate, Depth, and Resonance controls allow wide selection of swirling sounds with incredible depth and intensity Important Notes Please observe these precautions: • Inserting the plug of the instrument cable into the input (IN) jack will switch on the pedal's power supply. Remove the plug from the input (IN) jack when not using the unit to prolong the battery life. • The sound quality will degrade quickly when the LED indicator dims. Replace the battery immediately. Only alkaline batteries are recommended for longest life and reliability. • When not using the unit for a long time, remove the battery to avoid damage from battery leakage. • Use only the optional Nady PAD-1 adapter for externally powering your pedal. If you're not going to use it for an extended period of time, disconnect the AC adapter from the AC outlet. Also, when using the adapter, do not share the same power circuit with devices that generate line noise, such as electric motors or lighting dimmers, etc. Please note it is not unusual for the adapter to get very warm in use - this is normal. If there is a battery in the unit while using the PAD-1 AC adapter, normal operation will not be interrupted if the power from the AC adapter is cut off for any reason. • Don't remove the screws on the bottom or attempt to open the pedal. They are no user serviceable parts inside and any tampering with the circuitry will avoid the warranty. • Transport the unit in the box provided (including padding). Rough handling can cause malfunctions and physical damage not covered by warranty. • Grasp the connecter itself whenever connecting/disconnecting all cables - never only pull on the cable.