Nady MPM 8175x Owners Manual - Page 5
Front Connections
View all Nady MPM 8175x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
(2) (1) FRONT CONNECTIONS (8) (9) (3) (4) (5) FRONT PANEL (6b) (6c) (6a) (7) Note: 1 through 5 below are referenced to Channel 1. The other 7 Channels are identical. (1) LOW EQ The control shelving response giving 15dB of boost or cut at 80Hz. Add warmth to vocals or extra punch to guitars, drums and synths by turning to the right. Turn to the left to reduce stage rumble, hum or to improve a mushy sound. (2) HIGH EQ Turn to the right to boost high frequencies, adding crispness too percussion from drum machines, cymbals and synths. Turn to the left to cut these frequencies, reducing sibilance or hiss. The control has a shelving response giving 15dB of boost or cut at 12kHz. . (3) LEVEL CONTROL The Level Control determines the proportion of the channel signal in the mix, and provides a clear visual indication of channel level. (4) MIC/LINE INPUTS (6) DIGITAL DELAY The signal from the input channels, processed by the built-in digital delay will feed to the master output. There are three knobs here to control the effect of the delay. (6a) SWITCH This push button switches the delay effect ON/OFF. (6b) LEVEL This knob adjusts the mix level of the effect sound. (6c) TIME (ms) This knob selects 80ms, 120ms, 160ms, or 200ms of delay as desired for your intended effect. (7) POWER ON LED INDICATOR Indicates when the unit is ON. (8) TAPE IN CONTROL This knob adjusts the level of signal from the TAPE IN (10) to the Main bus. The MIC Input is via an XLR connector. Please use a low impedance microphone and a properly wired cable for best results. The LINE Input connection is made via a 1/4" TRS jack. This Input Is balanced and can accommodate either a Mic or Line level Input source. (9) MASTER CONTROL This adjusts the signal level of the Main bus. This is the signal that is output to the speakers. (5) DIGITAL DELAY (DD) This knob determines the signal level which will be sent to the built-in DIGITAL DELAY Effect (6) control 5