Nady PPA-300 Manual - Page 7
S P E C I F I C AT I O N S
 |
View all Nady PPA-300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
S P E C I F I C AT I O N S POWER SPECIFICATIONS OUTPUT POWER (EIA 1KHz 1% THD 120W RMS @ 8 ohms per side 150W RMS @ 4 ohms per side ELECTRICAL SPECIFICATIONS INPUT SENSITIVITY ...500V RMS (-4dBu) INPUT IMPEDANCE ...50K Unbalanced & Balanced FREQUENCY RESPONSE (at 10dB below rated output power 20Hz~20KHz ±1dB 5Hz~50KHz ±3dB DISTORTION ...
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
7
S P E C I F I C AT I O N S
The specifications above are correct at the time of printing of this manual. For improvement purposes, all specifications for this unit, including design
and appearance, are subject to change without prior notice.
PO
WER SPECIFICA
TIONS
OUTPUT POWER (EIA 1KHz 1% THD)
..........................................................................
120W RMS @ 8 ohms per side
150W RMS @ 4 ohms per side
ELECTRICAL SPECIFICA
TIONS
INPUT SENSITIVITY
...........................................................................................................................
500V RMS (-4dBu)
INPUT IMPEDANCE
..........................................................................................................
50K Unbalanced & Balanced
FREQUENCY RESPONSE (at 10dB below rated output power)
........................................................
20Hz~20KHz ±1dB
5Hz~50KHz ±3dB
DISTORTION
..............................................................................................................................................................
<.1%
S/N RATIO
................................................................................................................................................................
100dB
GENERAL SPECIFICA
TIONS
PROTECTIONS
......................................................................
Full short circuit, open circuit, thermal, ultrasonic, and RF
protection; stable into reactive or mismatched loads; ON/OFF muting; current limiter
FRONT CONTROLS
............................................................................
Power switch, input level control for each channel
REAR PANEL CONTROLS
......................................................................................................
AC voltage selector switch
CONNECTORS
......................................................................................................................
Power; IEC power cord jack
Input: Active balanced XLR and 1/4” (6.3mm) TRS
Output: dual 1/4” speaker jacks
POWER SUPPLY
..................................................................................................................................
110V~120V 60 HZ
FUSE
............................................................................................................................................
115V AC ~ 5A 250V FB
DIMENSIONS
..........................................................................................................
19” x 9.6” x 3.5” (483 x 244 x 89 mm)
WEIGHT
....................................................................................................................................................
16.6 lbs. (7.5Kg)