Naxa NHS-2012A English Manual - Page 11
Battery Installation Of Remote Control
View all Naxa NHS-2012A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
BATTERY INSTALLATION OF REMOTE CONTROL USING AT FIRST TIME ●Remove and discard the insulation film as figure on the right. REPLACING BATTERY 1. Push and slide out the battery holder as figure 1 below. 2. Replace the battery with a new CR2025 button cell as the polarity markings on the rear of the Remote Control. 3. Close the battery holder. CR2025 SN + OPEN PUSH RELEASE Fig.1 Fig.2 Fig.3 BATTERY PRECAUTIONS Follow these precautions when using a battery in this device: 1. Use only the size and type of battery specified. 2. Be sure to follow the correct polarity when installing the battery as indicated in the battery compartment, a reserved battery may cause damage to the device. 3. Do not mix different types of batteries together ( e.g: Alkaline and Carbon -zinc ) or old batteries with fresh ones. 4. If the batteries in the device are consumed or the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible leakage. 5. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture. ( Follow battery manufacturer's instructions.) 6. The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. 7. Clean the battery contacts and also those of the device prior to battery installation. 8. The remote control supplied with a coin/button cell battery. If the coin button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep new and used battery away from children. If the Battery compartment does not close securely, CR2025 stop using the product and keep it away from children. If you think batteries might have been swallowed or placed any part of the body, seek immediate medical attention. CAUTION ●Danger of explosion if the battery is incorrectly replaced. ●Replace only with the same or equivalent type. REMOTE CONTROL OPERATION ●When there is an obstacle between the transmitter and the unit, the unit may not operate. ●When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light shines on the REMOTE SENSOR of the unit, the operation of the remote may be unstable. 11