Naxa NPB-270 NPB-270 manual - English - Page 13

Using the AUX Input Set the FUNCTION switch [14] to the CD, FM, or BT position to play devices connected to the AUX Input jack [17]. LLThe unit will switch to AUX mode automatically when a player is connected to its AUX input jack [17]. 1. Connect the audio source to the player. Use an optional audio patch cable (not included) to connect the 3.5mm headphone or line-out jack of the audio source to the 3.5mm AUX Input jack [17] found on the rear of the player. LLUse the audio source to control playback (e.g., stop, play, next). Use the player to control the volume. Remember to disconnect the audio patch cable from the AUX input jack [17] after use in order to be able to listen to the radio or CD player again. 2. Prepare the player. Set the FUNCTION switch [14] to any position other than "OFF". Turn the VOLUME dial [15] to lower the volume level. 3. Prepare the audio source. Start playback on the device. Set the volume level of the device to approximately 80% of its maximum. 4. Adjust the final volume. Turn the VOLUME dial [15] of the player to set the volume to a comfortable level. www.naxa.com Page 13