Netgear ANT24BDC Installation Guide - Page 5

Installing the Booster with the Optional Power Injector Note: As noted in the illustration below, be sure to disconnect the DC power adapter from the ANT24BNA Booster for 802.11b, and connect it to the NETGEAR ANT24BDC Power Injector. Current antenna Do NOT remove Antenna e. g. NETGEAR ANT24O5 Connect Antenna cable Connect Antenna cable NETGEAR Antenna cable (short or medium) Injector NETGEAR ANT24BDC Connect Antenna cable Do NOT connect DC cable Wireless unit RESET ETHERNET 5-12V DC Primary Secondary Connect DC cable DC Block NETGEAR Connect Antenna cable NETGEAR Antenna cable (short) 500 mW Booster ANT24BNA Connect Antenna cable NETGEAR Antenna cable (medium or long) 6 Specifications Description Frequency Range Operating Mode DC Surge Protection Current Drain (TDD Mode) Transmit Power Transmit Input Power Transmit Ramp Up Time Receiver Gain Receiver Frequency Response Receiver Noise Figure Receiver Ramp Down Time Material Color Device Size (l x w x h) Weight RF Connector Type RF Connector Impedance RF Connector Dielectric Withstanding Voltage RF Connector Insertion Loss NETGEAR 500mW Bi-directional Booster for 802.11b, with Two Female Reverse SMA Connectors 2400 to 2500 MHz TDD Burst Mode 600 Watts TVS @ 6VDC 700 mA type. @ 6VDC 26.5 dBm minimum + 5 dBm minimum 3 µs maximum 10 dB typical ±1 dB over operating range 5 dB maximum 3 µs maximum ABS White 130 x 75 x 37 mm (5.1 x 3.0 x 1.5 in) 5.0 g/1.1 lbs (including DC adapter) SMA female reverse (2x), 1 for connection to antenna, 1 for connection to ME103 wireless access point 50 ± 5 Ohms 750 VRMS maximum 0.2 dB 7