Netgear DG834G DG834Gv2 Reference Manual - Page 112
VPN Tunnel Configuration, How to Set Up a Client-to-Gateway VPN Configuration
UPC - 606449029918
View all Netgear DG834G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Reference Manual for the Model Wireless ADSL Firewall Router DG834G VPN Tunnel Configuration There are two tunnel configurations and three ways to configure them: • Use the VPN Wizard to configure a VPN tunnel (recommended for most situations): - See "How to Set Up a Client-to-Gateway VPN Configuration" on page 8-6. - See "How to Set Up a Gateway-to-Gateway VPN Configuration" on page 8-20. • See "Using Auto Policy to Configure VPN Tunnels" on page 8-36 when the VPN Wizard and its VPNC defaults (see Table 8-2 on page 8-5) are not appropriate for your special circumstances, but you want to automate the Internet Key Exchange (IKE) setup. • See "Using Manual Policy to Configure VPN Tunnels" on page 8-48 when the VPN Wizard and its VPNC defaults (see Table 8-2 on page 8-5) are not appropriate for your special circumstances and you must specify each phase of the connection. You manually enter all the authentication and key parameters. You have more control over the process, however the process is more complex and there are more opportunities for errors or configuration mismatches between your DG834G and the corresponding VPN endpoint gateway or client workstation. How to Set Up a Client-to-Gateway VPN Configuration Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a network gateway (see Figure 8-3) involves the following two steps: • "Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834G" on page 8-7 uses the VPN Wizard to configure the VPN tunnel between the remote PC and network gateway. • "Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC" on page 8-12 configures the NETGEAR ProSafe VPN Client endpoint. 8-6 Virtual Private Networking (Advanced Feature) 202-10006-05, June 2005