Netgear FS524NA Installation Guide - Page 9

Connect Devices to the Switch Before connecting the switch, be sure you review "Applications" for information about determining the appropriate configuration for your networking needs. To connect the switch: 1. Connect the devices to the 10/100 Mbps ports on the switch, using Category 5 UTP cable and an RJ-45 plug. Note: Ethernet specifications limit the cable length between your PC or server and the switch to 328 feet (100 meters) in length. 2. Set the Normal/Uplink push button. 3. Set the FDX/AUTO toggle switches on the rear panel for the selected duplex mode (the default setting is AUTO). 4. Connect one end of the DC power adapter cable to the power outlet on the rear panel of the switch and the other end of the power adapter cable to the wall outlet. Refer to the following illustration when connecting the switch. Each of the preceding steps has a corresponding reference number in the illustration. Key 100 Mbps 10 Mbps 1 8 FDX Duplex Mode AUTO 3 ** 1 RJ-45 connector 16PO10R/1T00Mbps Fast Ethernet Switch Power 10/100AMutbops10/100 1U0t/i1li0za0tiMonb%ps Mbps Utilization% 1 Link FDX 13 Link FDX 8 MODEL FS516 1N6ormal/Uplink Normal/Uplink 2* * Normal/Uplink push button set to the Normal position for connection to the server. ** For a typical configuration, set toggle switches to AUTO. For more information, refer to "FDX/AUTO Duplex Toggle Switches." 4 9195FA Model FS516/FS524 Fast Ethernet Switch Installation Guide